A Multi Asperity Model of Contact Between a Smooth Sphere and a Rough Flat Surface in Presence of Adhesion
Journal Title: Tribology in Industry - Year 2011, Vol 33, Issue 1
Abstract
Multi asperity elastic-plastic adhesive contact between a smooth sphere and a rough flat surface is considered. To incorporate the effect of adhesion, JKR (Johnson–Kendall–Roberts) contacts are assumed and the mixed asperity contact model for a sphere with rough flats, developed by Kagami et al, is used. The results are obtained in terms of plots of radial pressure distribution, contact radius versus load, and compliance versus load and they are studied for different conditions that arise from varying loading and material parameters. The results obtained exhibit a negative pressure region at the edge of contact. It is observed that larger sphere radius gives lower pressure distribution and lower compliance.
Authors and Affiliations
A. MITRA, P. SAHOO, K. SAHA
Defining a Theoretical Model of Wear - Caused Failure of Tool Machine Elements
This paper considers production equipment failures caused by wear. A short overview is given on the results of statistically processed data on production equipment failures, gained by observing 20 representative and, fro...
Frictional Study of Al 6061 Red-Mud Composite under the Influence of Different Process Parameters
Metal matrix composite having aluminium 6061 as matrix incorporating red mud reinforcement has been casted by employing stir casting. Scanning electron microscopy images has been taken to observe the uniformity of the re...
Surface Roughness Analysis in High Speed Turning of Ti-6Al-4V Using Coated Carbide Inserts: Experimental and Modeling Studies
Machining and achieving good surface finish in Ti-6Al-4V is a challenging task. Several factors influence surface finish of which some can be controlled and are mainly the machining parameters and some are considered unc...
CNTs, Al2O3 and SiO2 Reinforced Epoxy: Tribological Properties of Polymer Nanocomposites
The present work studied the effect of filling epoxy matrix by different types and concentrations of nanoparticles on the friction and wear behaviors. Various concentrations (0.2 %, 0.4 %, 0.6 %, 0.8 % and 1 wt.%) of mul...
Wear Micro-Mechanisms of Composite WC-Co/Cr - NiCrFeBSiC Coatings. Part I: Dry Sliding
The influence of the cermet fraction in cermet/ metal composite coatings developed by High-Velocity Oxyfuel Flame (HVOF) spraying on their tribological behaviour was studied. Five series of coatings, each one containing...