Ocena jakości warstw nakładanych metodą laserowego osadzania metalu w proszku LDT
Journal Title: Autobusy. Technika, Eksploatacja, Systemy Transportowe - Year 2018, Vol 220, Issue 6
Abstract
The article presents the results of a study of C45 carbon steel hardfacing using laser metal deposition with Stellit Co-21 powder. The microstructure of the cross-section of samples prepared with different scanning speed and the amount of used powder at constant laser power was observed. Analyzing the cross-sectional areas of the samples, it was found that, at specific production parameters, cracks occur in weld overlay, which should be associated with the amount of heat supplied and discharged, especially at the unheated basis.This may be confirmed by the presence of deposits of weakly branched dendrites in the microstructure, which should be related to the directional heat dissipation process and rapid directional crystallization. It is possible to regulate these phenomena by selecting appropriate processing parameters. The microstructure analysis of cross-sectional areas of samples after hardfacing using LDT technique indicates good metallurgical quality of the deposit with a small heat affected zone of about 660÷760mm. The microhardness measurements on the sample cross-sections indicated a wide micohardness distribution ranging from 510HV1 in the weld overlay, about 410HV1 in the heat affected zone, to 270HV1 in the C45 steel base.
Authors and Affiliations
Andrzej Mazurkiewicz
Keywords
Related Articles
- EP ID EP561834
- DOI 10.24136/atest.2018.140
- Views 27
- Downloads 0
Działania na rzecz rozwoju transportu zrównoważonego w Rzeszowie
The article presented the problems connected with the operation of people transport in cities. The dynamic development of cities and the increase in the income of the population has in many cases contributed to limiting...
Dobór nastaw regulatorów PID dla quadrocoptera z wykorzystaniem metod optymalizacyjnych w programie Wolfram Mathematica
The article presents the method of modeling the dynamics of a quadrocopter and presents a method for the selection of PID regulators. The quadrocopter's dynamics were derived based on the Lagrange equations of the second...
Analiza systemów oczyszczania spalin i metod ich regeneracji
The article describes the types of exhaust after-treatment systems in vehicles and trucks. It presents a systematized knowledge about various technological solutions used in those systems. Moreover, it identifies the cau...
Obszary zagrożeń realizacji kolejowych przewozów towarowych
W 2017 roku zauważalny jest wzrost przewozów ładunków transportem kolejowym. Prowadzona przez Unię Europejską polityka transportowa, inwestycje infrastrukturalne oraz możliwości związane z Nowym Jedwabnym Szlakiem wskazu...
Miejsce strat w drogownictwie i transporcie w systematyce strat ekologicznych w Polsce
The classification of enviromental pollution effects by Kazimierz Górka and Bazyli Poskrobko presented in the article is the fullest systematics of the economic losses in Poland. On the basis of this classification we ha...