A Fault Detection and Protection Scheme for A 200 MVA Transformer Using Fuzzy Logic
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2018, Vol 13, Issue 2
Abstract
The paper elucidates a fault detection and protection scheme for a 200MVA transformer using Fuzzy logic. Fuzzy logic (FL) tool box in MATLAB/ SIMULINK software was utilized in the simulation system that diagnosed transformer faults and also monitors its operating conditions. Current and rate of change of current with time have been identified as the input variables, duly represented in the programme as “Error” and “Error-Dot”. These variables have their universe of discourse from -1.5 to 1.5 and from -10 to 10 respectively. Fuzzy logic sensor is designed to monitor the current (i) conditions of the transformer at both ambient and full load. The results from the research show that whenever the output response is zero the current in transformer is normal. This is obtained when input values of [0] and [0] are injected into the system to produce a response of “6e-017” which is approximately zero. Whereas if the output response is greater than zero it implies that the transformer current is rising beyond normal and protection scheme should be alerted. This condition is achieved when input values of [-1.5] and [5] are used on the system to give a response of “+5”. However, if the response is less than zero then the transformer current is below normal, hence the protection scheme should be alerted. To investigate this, input values of [1.5] and [-5] gives a response of “-5”.
Authors and Affiliations
S. O. Okolo, T. C. Madueme
Keywords
Related Articles
- EP ID EP388684
- DOI 10.9790/1676-1302011623.
- Views 136
- Downloads 0
Optimization Algorithms Used In Smart Grids and Comparison of Results
The electrical networks used today are established in 1883 according to the design principles published by Tesla. In time, due to the rapid development of technology has become unable to meet today's needs. In order to e...
DC To DC Boost Converter with High Voltage Gain
the main objective of this work is to produce a very high DC output voltage from a small input voltage. The input voltage range is from 4 to 6 DC voltages and the output voltage is 810 V with no load. Depending upon the...
A Simple Analytical Organized Information of different RTOS used in Embedded Systems
The embedded technology has been developed to a higher extent. The rtos has significant role in the development of embedded systems.In this paper different rtos features with respect to the parameters has been enlisted....
Assessment of Atmospheric Water Generator for Rural and Remote India
With increasing human population drinking water demands are going to constantly increase which is expected to deplete water sources at ever increasing rate. United Nations SDG goals recognize this issue and identifies ac...
Controlling and Analysis of Variable Wind Speed Turbine with DFIG Using Fuzzy Logic Controller
Wind power is growing source in this era of power generation from renewable sources. In India, the power generation from wind is 32562 MW in July 2017 and target for 2022 is 60,000 MW. The problems in front of controller...