A GENERALIZED MODEL OF WEAR TRIBOCORROSION
Journal Title: Tribologia - Year 2014, Vol 254, Issue 2
Abstract
The article attempts to approximate the results of studies of tribocorrosion wear of stainless steel AISI 304 and AISI 420 in 0.5 M H2SO4 solution. The tests were performed in a specialized position of the node model pin-on-plate. In particular, a series of differentiated pressures in the contact zone (p) and the frequency of counter-specimen movement (f) were used. The approximation model was used for wear in the general form: Ih = KpX (Ih – linear wear intensity, K, x – solid materials). Approximation obtained satisfactory results (correlation coefficient of 0.85 above). At the same time, it was found that the effectiveness of the applied model decreases with an increase in the rate of corrosion effects.
Authors and Affiliations
Arkadiusz STACHOWIAK, Wiesław ZWIERZYCKI
THE WEAR PERFORMANCE OF DIAMOND-LIKE CARBON COATINGS IN RELATION TO COATING COMPOSITION AND FRICTION PAIR
This study has been carried out to examine diamond like carbon coatings; a-C:H:W single-layer and TiN/a-C:H:W multilayer prepared on CoCrMo alloy by the PVD and PACVD technique. Information on the composition of amorphou...
THE INFLUENCE OF THE FRICTION PAIR LOAD ON TRIBOLOGICAL CHARACTERISTICS OF POLYMER COMPOSITES IN RECIPROCATING MOTION
This paper presents the influence of the friction pair load on the wear and friction coefficient of polymer composites in reciprocating motion. The tested polymer composites are used in regeneration purposes of supports...
Tarcie, zużycie i właściwości mechaniczne kompozytów silikonowych zawierających modyfikowane powierzchniowo napełniacze mineralne
A TRIBOLOGICAL DEVICE FOR TESTS IN DIFFICULT EXPLOITATION CONDITIONS OF BEARING COMPONENTS WITH A MODIFIED SURFACE LAYER
This paper describes the construction of a tribological device in ring-on-shaft configuration. The constructed set-up is available for investigations of sliding bearing components for AIRBUS aircraft ventilation systems....
Opis uszkodzeń warstwy DLC i podłoża Si w badaniach mikrotwardości z rejestracją sygnału EA