A Novel Purely Active Electronically Controllable Configuration for Simulating Resistance in Floating Form
Journal Title: Elektronika - Year 2016, Vol 20, Issue 2
Abstract
This paper proposes a new purely active floating resistance simulation circuit employing two voltage differencing trans-conductance amplifiers (VDTAs). The proposed configuration enjoys following advantageous features; (i) purely active realization (ii) electronically tunable resistance (iii) no requirement of any active/passive component matching constraint (iv) good non-ideal behavior and (v) low sensitivity values. The Influence of VDTA terminal parasitics on high frequency behavior of proposed circuit is also investigated. The workability of proposed resistor simulator has been verified by an application example of voltage mode low-pass filter. To validate the theoretical analysis, SPICE simulations with TSMC 0.18µm CMOS process parameters have been performed.
Authors and Affiliations
Mayank Srivastava, Dinesh Prasad
Keywords
Related Articles
- EP ID EP362481
- DOI 10.7251/ELS1620090S
- Views 93
- Downloads 0
Design of a 1 DOF MEMS motion stage for a parallel plane geometry rheometer
Rotational rheometers are used to measure paste properties, but the test would take too long to be useful for quality control (QC) on the job site. In this paper, a new type of rheometer is proposed based on a one degree...
Simulation of a Pick-and-Place Cube Robot by Means of the Simulation Software Kuka Sim Pro
In this work the creation of the program code for industrial robot and the simulation of a robot cell by means of the simulation software KUKA Sim Pro in version 2.2.2, is presented. Simulated and programmed is, in reali...
Integrated Cost-Benefit Assessment of Customer-Driven Distributed Generation
Distributed generation (DG) has the potential to bring respectable benefits to electricity customers, distribution utilities and community in general. Among the customer benefits, the most important are the electricity b...
New Blood Level Measurement System in Blood Separating Machine
Standard versions of blood separators typically use medium-price color sensors for a detection of a boundary level between red blood cells and plasma, at the last gate – at hose clamps. Discrete number of sensors is rela...
Editor's Column
N/A