A Numerical-Analytical Hybrid Approach for the Identification of SDM Solar Cell Unknown Parameters
Journal Title: Engineering, Technology & Applied Science Research - Year 2018, Vol 8, Issue 3
Abstract
Appropriate modeling and accurate parameter identification of solar cells are crucial in the optimization of photovoltaic (PV) systems. The single-diode model (SDM), consisting of an ideal current source, an ideal diode, a shunt resistor and a series resistor, is widely used to simulate the behavior of PV cells/panels. In this article, a hybrid approach for identification of solar cell SDM parameters is presented. This approach uses the inverse of the slope of the I-V curve under short-circuit and open-circuit conditions and combines numerical and analytical solutions. Indeed, knowing that numerical methods require appropriate initial values, the main idea of the proposed approach is to provide these solutions by analytical methods. The comparison of obtained results with experimental ones, based on manufacturer’s datasheet, proves that the algorithm thus obtained requires less information from the manufacturer and improves significantly the parameter identification accuracy.
Authors and Affiliations
R. Abbassi, A. Boudjemline, A. Abbassi, A. Torchani, H. Gasmi, T. Guesmi
Keywords
Related Articles
- EP ID EP168794
- DOI -
- Views 284
- Downloads 0
Performance Analysis and Comparison of Symmetrical and Asymmetrical Dual Stator Induction Generators for Wind Energy Conversion Systems
The emergence of micro/nano level wind generation has opened the research on induction generator (IG) topologies having easier and finer control available in multiphase generators. To establish the suitability of multiph...
Wear Analysis of a Ti-5Al-3V-2.5Fe Alloy Using a Factorial Design Approach and Fractal Geometry
This paper describes the application of the full factorial experimental design technique to confirm the significance of the factors affecting the wear behavior of a recycled Ti-5Al-3V-2.5Fe alloy with a minimum number of...
Growth Mode Study of MgCl2 on Ti (0001) and SiO2 under Ultra High Vacuum by XPS
The growth mode of MgCl2 on Ti (0001) and on SiO2 grown on Si (100) was investigated by X-ray Photoelectron Spectroscopy (XPS) under UHV conditions. Magnesium chloride grows on both Ti (0001) single crystal and SiO2 foll...
Influence of Temperature on Energetic and Rheological Characteristics of PLANTOHYD Bio Lubricants – a Study in the Laboratory
This article presents the results of measuring the calorific value and the rheological characteristics of Plantohyd bio lubricants. Measurements were conducted under laboratory conditions with an IKA C5000 calorimeter an...
Microstructure and Wear Behavior of TiC Coating Deposited on Spheroidized Graphite Cast Iron Using Laser Surfacing
Spheroidal graphite cast iron was laser cladded with TiC powder using a YAG fiber laser at powers of 700, 1000, 1500 and 2000 W. The powder was preplaced on the surface of the specimens with 0.5 mm thickness. Sound cladd...