A STUDY OF PHASE TRANSFORMATION IN SHAPE MEMORY ALLOY CuAl9Fe4
Journal Title: Journal of Mechanical Engineering Research & Developments (JMERD) - Year 2019, Vol 42, Issue 2
Abstract
Microstructure and phase transformation in shape memory alloy Cu-Al (Fe addition: 9% Al, 4 % Fe) were investigated in this study. It is a material capable of restoring its original shape when impacted by a reasonable temperature or cyclic stress and production cost is not too expensive. In many years, shape memory alloys (SMA) based on Cu – Fe is considered to be very attractive to industrial and biomedical applications such as cardiovascular, orthopedic, surgery and production of spare parts and jigs. Original alloy exists β martensite and only exists 〖α^’〗_1 (3R)+ 〖β’〗_1(9R) + 〖γ^’〗_(1 ) (2H) which is finely dispersed homogenously in microstructure after finishing shape memory transformation. Shape memory rate obtained 6%-24% corresponding to each deformation angle before the experiment. Phase transformation between these two phases during deformation as well as the heating-cooling process which create the basis for the unique properties of the alloy.
Authors and Affiliations
Nguyen Duong Nam, Vu Anh Tuan, Nguyen Hai Yen, Dao Van Lap, Pham Mai Khanh
A NUMERICAL STUDY OF THE TURBULENCE MODEL INFLUENCE ON A SAVONIUS WIND TURBINE PERFORMANCE BY MEANS OF MOVING MESH
This numerical research has investigated the influence of the turbulence model on a Savonius wind turbine performance. The numerical simulation has been applied by using two-dimensional analysis of Computational Fluid Dy...
DATA MINING IN MECHANICS
The article is devoted to analysis of data mining techniques in a model of construction management. It is advisable to apply some well-developed methods of fuzzy sets and fuzzy logic. The original construction is describ...
EXPERIMENTAL DETERMINATION OF CHARACTERISTICS OF CRACK-RESISTANCE OF DISPERSE-STRENGTHENED COMPOSITES BASED ON NON-SATUTATED POLYESTERS
Based on the series of tests for three-point bending of rectangular bars with central cuts on a universal test machine, using the compliance and K-methods, experimental values of the fracture toughness characteristics of...
IMPROVED THE ADAPTATION FOR THREE PHASE ACTIVE FILTER UNDER NON-IDEAL-LOAD USING SAMPLE CURRENT CONTROL
In this paper, a comparison between sample current control and direct current control to show the efficiency of the two current control method of Active Power Filter. The main function of the scheme was a duty by the two...
MICROSTRUCTURE CHANGE FOR MULTI-PASS WELDING BETWEEN AUSTENITIC STAINLESS STEEL AND CARBON STEEL
The purpose of this study was to discuss the change in microstructures and hardness values in fusion zone (FZ) and heat-affected zone (HAZ) of austenitic stainless steel and carbon steel welds. By comparison, the morphol...