A study of the effect of electrostatic processing on performance characteristics of axle oil
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 1, Issue 1
Abstract
<p>The effect<strong> </strong>of electrostatic processing on performance characteristics of axle oil is investigated. Axle oil is used for wetting motor-axial bearings (MAB) of locomotives. There is a pressing and urgent problem of the MAB service life, which is indirectly related to the underdeveloped reserves of anti-wear properties of axle oil. To study them, it was decided to use the method of electrostatic processing, which does not require the introduction of any additives and has proven its effectiveness in the studies of other mineral oils. It is based on the ability of electric fields to destroy micellar aggregates in oil and form a solid boundary layer of molecules on friction surfaces. In the context of solving the current problem of the MAB service life, this method wasn’t considered earlier.</p><p>The research was carried out by means of the «roller-pad» friction pair, which was wetted with axle oil at different load conditions and operating times. The dependences of wear of the experimental samples under different load conditions, oil operating times and degrees of electric processing are obtained.</p><p>The results show that when using axle oil subjected to ESP, the wear rate of the experimental samples is reduced. Wear rate reduction depends on the oil operating time in the lubrication system. The greatest wear rate reduction of 1.92 times is noted for fresh oil. For the oil state after the locomotive run of 75 thousand km, the reduction is about 1.68 times and for the oil at the end of its service life, wear rate reduction is approximately 1.47 times.</p>
Authors and Affiliations
Pavlo Konovalov, Serhii Voronin, Dmytro Onopreychuk, Volodymyr Stefanov, Viktor Pashchenko, Hennadii Radionov, Aleksandr Onoprienko
Development of methodology for modeling the interaction of antagonistic agents in cybersecurity systems
<p>The basic concepts that form the basis of integrated modeling of the behavior of antagonistic agents in cybersecurity systems are identified. It is shown that the emphasis is largely on modeling the behavior of one of...
Effect of banana powder and butter on the formation of the crystalline phase of sugar fondant
<p>Taking into consideration modern requirements to technological characteristics of decorative semi-finished products, micronutrient composition, we developed the formulation for the innovative confectionery semi-finish...
Modeling the process of polymers processing in twinscrew extruders
<p>We developed a mathematical model of the process of polymer processing in co- and counter-rotating twin-screw extruders. The model takes into account a heat transfer of a polymer with screws and a barrel, as well as r...
Forecasting the estimated time of arrival for a cargo dispatch delivered by a freight train along a railway section
<p>This paper reports a method for predicting the expected time of arrival (ETA) of a cargo dispatch taking into consideration determining the duration at which a freight train travels along a railroad section where trai...
Organization of responsibility accounting of city electric transport enterprises’ activity
<p class="a">The problems of organization of responsibility accounting of the city electric transport (CET) enterprises' activity are considered. The industry specifics of the activity of tram and trolleybus enterprises...