A STUDY ON THE FACTORS AFFECTING THE FLARE OF THE WELD WHEN WELDING THE STEEL WIRE
Journal Title: Journal of Mechanical Engineering Research & Developments (JMERD) - Year 2019, Vol 42, Issue 3
Abstract
In this study, an equation for adjusting the parameters affecting the flare of the weld on the welding product was established. Based on the empirical research results, the factors affecting welding flux after using bending machines have been studied. It has showed that the factors like the press force, the welding mode, the welding current, and the welding time were the main factors afftecting directly the flaration of the weld. For the standard of the flare of the weld of 3.3 mm, the welding current was 22A, the welding time was 5 deci-seconds, and the press force was 2.78 Kg/cm2. The results showed that the automatic steel-wire welding after improving the welding machine and mode had a productivity of 5.8 times higher and reduced 20% of energy consumption compared to traditional welding methods. Compared with unmodified automatic welding, the productivity increased by 5.8%, energy decreased by 7%, and the weld quality was more stable.
Authors and Affiliations
Minh Quang Chau
Keywords
Related Articles
- EP ID EP572224
- DOI 10.26480/jmerd.03.2019.71.75
- Views 74
- Downloads 0
CORRELATION OF OVERALL HEAT TRANSFER COEFFICIENT IN THE THREE ZONES OF WIRE AND TUBE CONDENSER
Numerical and experimental analysis has been studied to estimate the overall heat transfer coefficient in the three zones along wire and tube condenser. The model is based on the empirical formulation of the refrigerant...
ANALYSIS OF THE FAILURE-FREE OPERATION OF THE PASSIVE REDUNDANT SUBSYSTEMS OF THE AIRCRAFT WITH DUE CONSIDERATION OF THE TOLERANCES
The goal of this paper is to examine the failure-free operation of the passive redundant subsystems of the aircraft with due consideration of the tolerances for decrease of their output parameters in the cases of failure...
EFFECT OF CROSS FLOW ON MASS SUCTION IN A STRAIGHT LOUVERED FUNNEL
In this study, the effect of wind on the mass suction ratio in case of a straight louvered infra-red suppression device (IRS) has been studied using numerical simulations. Two types of configurations were studied. In the...
COMPUTER WITH CHANGEABLE ARCHITECTURE
The relevance of this article is that, despite the rapid development of computer technologies, it has not been yet invented the architecture that did not have vulnerabilities for hacker attacks. The purpose of the paper...
LEARNING OUTCOMES FOR TRAINING PROGRAM BY CDIO APPROACH APPLIED TO MECHANICAL INDUSTRY 4.0
The CDIO approach (Conceive-Design-Implement-Operate) is a model of educational reforms in technical universities towards meeting the needs of careers in the corporate and social context. The paper presents the need to b...