Adjusting the size of the rope thread in the machining of dimensional tool
Journal Title: Журнал інженерних наук - Year 2016, Vol 3, Issue 1
Abstract
The article considers the possibility of adjustment the geometrical deviations profile rope thread with a large pitch, which appear as a consequence of wear of the cutting tool during machining. Due to the fact that the method of processing rope thread easily modeled by cutting the circle along a spiral trajectory, then this method easily explore the any medium for 3-D modeling. Conducted analysis of influence of trajectory of the dimensional instrument and the value of its wear on the thread diameters and the radiuses of rounding. The results allow establishing that due to changes in the tool path correction is possible geometrical parameters of rope thread, hereby will process with ensuring the required geometry. The proposed approach is reduces the cost of the cutting tool by increasing its resources.
Authors and Affiliations
S. Nekrasov, E. Ageeva
Keywords
Related Articles
- EP ID EP241705
- DOI -
- Views 85
- Downloads 0
Influence effect of electric action on the micro structure of steel in crystallization
The dependence of physical and mechanical properties of manganese steel grade 110H13L on the effect of electrical activity during crystallization of the casting is considered. Treatment of the melt by electric current in...
Comparison between PID and Artificial Neural Networks to Control of Boiler for Steam Power Plant
This paper presents is to develop and compare neural network and conventional based controllers for a boiler of steam power plant. Designs of two different controllers for pressure and temperature are presented for keepi...
Special aspects of machining of internal threads by measure tool
Based on an analysis of recent studies of various machining methods the disadvantages of existing methods of internal threads machining have been identified. The proposed method of machining round threads by up to measur...
Analytical determination of the frequency of short circuits of the arc at surfacing in gas dioxide with welding pool mechanical oscillations
A hypothesis has been put forward that it is possible to reduce the degree of splashing when sur-facing into carbon dioxide due to the setting of the frequency characteristics of the oscillation of the weld pool. Equatio...
Development of curvilinear blade impeller of vortex pump based on numerical simulation
The present paper focuses on study of relation between impeller outlet width and the slope of characteristic curve. In order to figure out this relation on the different operation modes the numerical simulation was used....