Advantages of using channels with different corrugation height in the plate heat exchangers
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 1, Issue 8
Abstract
<p>In the case when there is a difference in consumption on the side of the cold and hot heat carriers, the use of channels with the same corrugation height in one heat exchanger leads to a decrease in velocity of the heat carrier on the side with low consumption.</p><p>Low velocity contributes to appearance of deposits on the heat transfer surface, which leads to disruption of operation mode of the apparatus and a forced clean-up stop. In case of using channels with a different corrugation height (cross-section area), velocities in the channels are aligned and intensity of emergence and growth of contamination falls sharply. It also allows us to reduce the heat transfer surface area of the apparatus and fully implement permissible pressure losses on the sides of the heat exchanger. For designing of heat exchangers of this structure, the authors developed the mathematical model that allows making calculations of heat exchangers for assigned operation conditions with the use of geometrical data of the plates, thermophysical properties of heat carriers and criterial equations for plates of the selected type.</p><p>The calculation algorithm involves determining of the ratio between corrugation heights. Practical value lies in the fact that the proposed approach makes it possible to extend the service life of the heat exchanger prior to a maintenance stop. This enables provision of continuity of the technological process and decreases operation costs. Calculation of the heat exchanger of hot water supply by the parallel scheme of attachment to heating networks and the heat exchanger of stage 1 of the two-stage hybrid scheme was presented. Calculation data indicate a decrease in the heat transfer surface area compared to heat exchangers with channels of equal height, full realization of pressure losses and their alignment in the channels, which facilitates an increase in resistance to contamination of the plates’ surface.</p><p class="a">Calculation showed the advantage of using apparatuses with channels of different cross-section area. The higher the ratio between consumption of heat carriers in the channels, the stronger this advantage.</p>
Authors and Affiliations
Gennadii Khavin, Tatiana Babak
Keywords
Related Articles
- EP ID EP527788
- DOI 10.15587/1729-4061.2018.120546
- Views 44
- Downloads 0
Development of a method for optimizing operation of centrifugal gas superchargers under conditions of uncertainty
<p>A problem of development of a method of optimal control of operation of natural gas superchargers by a criterion which both minimizes fuel gas consumption and takes into account power of nitrogen oxide emissions into...
Construction of a method for predicting the number of enterobacteria in milk using artifical neural networks
<p>It is now established that artificial neural networks (ANNs) provide better simulation and prediction of the number of microorganisms in raw materials and foodstuffs. In this case, ANNs could be used as informative, f...
Aloe vera as cutting fluid optimization using response surface method
<p>The fluid of vegetable Aloe Vera has characteristics as a cutting fluid, Aloe Vera cutting fluid (AVCF) has an excess of environmental reduction effects from oil-based cutting fluid (OBCF). Surface Response Methodolog...
Development of a model of the weight of motor roads parameters as part of the information and management system of monetary evaluation
<p>The article deals with the approaches to the construction of a multi-level hierarchical system of indicators for evaluation of the quality state of a motor road section. The model of the weight of parameters and chara...
Improving efficiency of machining the geometrically complex shaped surfaces by milling with a fixed shift of the cutting edge
<p>In order to improve efficiency of machining by milling geometrically complex shaped surfaces, mainly the methods related to improvement of properties of the tool material, change of composition and properties of the t...