An Analytical Procedure for the Prediction of the Stress-Strain State in Notches under Multiaxial Fatigue
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2008, Vol 31, Issue 2
Abstract
This work presents an analytical procedure for estimating elastic-plastic stresses and strains in notched shafts subjected to synchronous non-proportional torsional and tensile cyclic loading. The specification of the equivalent stress concentration factor is firstly accomplished. Neuber’s rule in conjunction with the assumed material law provides the relation between the applied loading and the equivalent stress and strain. Principal stresses and strains yield from the corresponding equivalent values incorporating Hencky’s equations. The transformation of the principal stresses and strains to the appropriate coordinate system yields the final result. For the assessment of the analytical procedure, notch stress-strain results from several finite element analyses of an axisymmetric cylindrical shaft with a circumferential groove subjected to multiaxial synchronous fatigue loading are presented. A satisfactory agreement between the analytical and numerical results is observed.
Authors and Affiliations
Nikolas PITATZIS, Alexander SAVAIDIS, Georgios SAVAIDIS
Electrochemical Modifications of Titanium and Titanium Alloys Surface for Biomedical Applications – A Review
The field of biomaterials requires the input of knowledge from very different areas such as biology, medicine and engineering so that the implanted material in a living body to not induce any adverse impacts. The paper f...
Preparation and Characterization of Tin Oxide Thin Films
Tin oxide (SnO) thin films were prepared onto glass substrates by thermal evaporation under vacuum. The substrate temperature was kept constant at 300 K during the film growth. The structural studies using transmission e...
Study Regarding Gravimetrical Corrosion of the Superficial Layers Obtained through Electrical Discharge
The experimental research was made on superficial layers laid-down through electrical sparking on the steel carbon OLC 45 probes, the used electrode being made from a corrosion resistant material (Copper). The probes was...
Laser Surface Alloying of Some Steels from SiC Predeposited Powders
For the purpose of studying the possibilities of increasing the wear resistance, specimens of three steels with 0.2%C, 0.46%C and 1%C were surface alloyed with reinforcement from overlapping pastes with green SiC hard pa...
Processing Smart Wires from Cu-Al-Ni System
In this paper we present some results concerning plastic deformation applied to shape memory alloy and two most direct characterization methods for shape memory. We work with a copper based alloy- Cu Al13Ni 4. Over eight...