An Effect of Stress Relieving on the Microstructural and Mechanical Properties of Mg-3Zn-1Cu-0.7Mn/ Al2O3 Composite Synthesized by Powder Metallurgy
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 4
Abstract
A composite based on Mg-3Zn-1Cu-0.7Mn alloy reinforced withAl2O3was synthesized using blend-press-sinter powder metallurgy route and hot extruded at 400oC. The study concentrates on investigating the effectiveness of alumina as reinforcement and analyzing the effect of stress relieving on the mechanical and microstructural properties of the composite. The results of the study indicate that the ultimate tensile strength, yield strength and fracture strain of the composite was increased in the composite compared to the pure Mg metal. It is also proved that stress relieving has a significant role on the ultimate tensile strength and fracture strain in the composite.
Authors and Affiliations
Silan Tharakan . S, M. Sivapragash, Suneesh . E
Keywords
Related Articles
- EP ID EP655652
- DOI 10.24247/ijmperdaug201936
- Views 89
- Downloads 0
EXPERIMENTAL INVESTIGATION OF PERFORMANCE AND EMISSION CHARACTERISTICS OF AN IDI DIESEL ENGINE USING HOMOGENIZED WATER IN DIESEL EMULSION
A comparative experimental study on a 1.8L IDI diesel engine has been carried out to evaluate the influence of homogenized water in diesel emulsion on performance and exhaust emissions against base fuel diesel. The emuls...
Performance Analysis of 4-S, 2-CC. I Engine with roselle Oil Methyl Esters with Added Ignition Improver
In the present work, performance analysis of twin cylinder CI engine is performed. Roselle seed oil methyl esters are extracted from the crude roselle oil by the method of trans-esterification. The tests are conducted in...
A Review on Metallic Dental Materials and its Fabrication Techniques
Evolutions of metallic dental restorative materials are facilitated due to need in improvement in its quality such as mach in ability and aesthetics. Availability of numerous substitutes and advancement in the manufactur...
PHYSICAL SIMULATION FOR HOT ROLLING POLICY OF ELECTRICAL SI–STEELS
The present work is dealing with three Si-steel alloys. Representative samples were taken and machined from the as- cast ingots to suite the thermo mechanical simulator. The physical simulation process consists of heatin...
Synthesis Characterization and Mechanical Behavior of Rice Husk Ash Reinforced Al-20mg 10 Cu Alloy Matrix Hybrid Composites
The aim of this work is to fabricate hybrid composites by using Rice husk ash (RHA), an agro waste as reinforcement to AL-20MG-10CU high strength alloy. Rice husk ash particles of 3, 6, 9 & 12 % by weight were used, to d...