AN OPTIMAL DESIGN OF CONNECTIVITY OF THE ELECTRIC CURRENT TO A STAND-ALONE COMPLEX BY USING THE SOLAR CELLS
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 4
Abstract
In recent days, the increasing demand for electrical energy has led to a significant need for power for the renewable energy. Producing the electric current from the Solar Energy (SE) is one of the best sources of renewable energies. The most significant problem facing designers of (SE) systems for individual buildings is the problem of lack of flat roof areas of these buildings, especially in the stand-alone systems where the solar panels take a considerable amount of space. Therefore, most scientific research in the field depends on "How to reduce the solar panel area with a high efficiency and power production." It is also possible that the available area gives a large surplus of useless energy. The problem of the vast horizontal areas of solar panels can be solved in the stand-alone systems, where each solar system installed on every building feeds that same building and feeds its surplus energy in main busbar around the complex. The main busbar around the complex provides each building with the required energy and uses the surplus energy from all buildings to provide another load. This paper introduces a complete design system of integrating photovoltaic/battery storage to a stand-alone complex isolated about the utility grid system "Off Grid system” with variety and different loads by using distributed solar cells to reach the highest efficiency and economical operation of the distribution system.
Authors and Affiliations
KHALID. M HAMID, AHMED S ADAIL, SALAMA. A ABO-ALELA, ELGAZZAR M. M
Keywords
Related Articles
- EP ID EP430518
- DOI -
- Views 82
- Downloads 0
AL3O2 AND NICKEL COATINGS ON RESISTANCE WELDING ELECTRODES USING CHEMICAL VAPOUR DEPOSITION PROCESS TO EXTEND LIFE
Any alteration in the standard machining process can lower the quality of finished product. This is especially true in high-speed machining operations, where despite the pace, the quality of the product and physical dime...
Advanced Fabricated Setup for Day Long Production of Hot Water by Fresnel Lens
This work has been aimed to collect the solar energy source from Fresnel lens and utilize it to produce hot water or steam. The setup consists of a large spot Fresnel lens which concentrates the sun's rays into a one-cen...
A Study on the Increasing Risks(Trauma) Related to an Ambulance for a Paramedic and Patient- A Review
This paper is to evaluate the effectiveness of pre-hospital emergency care. The objective of this review is to study how the ambulance’s transport time can be reduced. It aims to address the waiting time of the patient b...
Fabrication of Aluminium 6061- SiC-Al2O3 MMC and HMMC by Strir Casting Technique and Comparing the Mechanical Properties
Aluminum alloys are extensively used in aerospace and automobile industries owing to their low density and good mechanical properties, superior corrosion resistance and wear, low thermal coefficient of expansion as compa...
Optimization of Design Parameters of Bellows Expansion Joints
A technique for optimizing the design parameters of the metal corrugated shell of bellows expansion joints is proposed. The purpose of the development is to improve the accuracy of resource assignment, as well as further...