Analiza emisji tlenku węgla z pojazdu z silnikiem o zapłonie iskrowym i bezpośrednim wtryskiem paliwa według procedury RDE
Journal Title: Autobusy. Technika, Eksploatacja, Systemy Transportowe - Year 2017, Vol 214, Issue 12
Abstract
The paper presents an analysis of the carbon monoxide emissions from a vehicle with spark-ignition engine and direct fuel injection. The study was conducted under real traffic conditions, following the RDE (Real Drive Emission) procedure. The test was carried out in the area of Poznań agglomeration, the route covered roads with different permissible speeds. The tests were carried out using the SEMTECH DS mobile device, belonging to the PEMS (Portable Emission Measurement System) group.
Authors and Affiliations
Piotr Lijewski, Natalia Szymlet, Barbara Sokolnicka, Maciej Siedlecki
Tarcie oraz jego wpływ na stabilność pracy wybranych wirujących zespołów mechanicznych, Cz. 1
This paper is devoted to a friction phenomenon, its classification and influence on work stabilization of the rotating mechanical modules. There has been considered a case of multi-cylinder engines crankshafts that are p...
Model sterowania przepływem materiałów w procesie produkcyjnym
In production enterprises production logistics is the most important link of the company. We particularly pay attention to wastage and look for possibilities of reducing costs. Improvements in the production area, the su...
The modern offshor oil detection and monitoring systems
This article describes the general principles of operation of radar systems for detecting oil spills in the offshore sector. First of all, the article contains operational context of the DSO system.
Koncepcja wykorzystania dronów w ratownictwie drogowym
An article presents prospects and examples of drone - Unmanned Aerial Vehicle use in road rescue. There was presented the Drone Road Rescue System, which would be created from combining drones used for road monitoring an...
Assessment of the critical values of stress and strain of material on the basis of analysis of uniaxial tensile test data
In the article, a method of determining the critical level of deformation of ferritic steel S355JR on the basis of measurements of grain elongation is proposed. Tests were carried out on steel in two microstructure state...