Analysis and Fabrication of an Active Cooling System for Reducing Photovoltaic Module Temperature
Journal Title: Engineering, Technology & Applied Science Research - Year 2017, Vol 7, Issue 5
Abstract
The purpose of this study is to fabricate and analyze an active cooling system for reducing photovoltaic (PV) module temperature and increasing its efficiency. An active cooling system was devised to cool the PV module. Two modules of same specifications were used for this study. One module was cooled, and other was left un-cooled for performance comparison. Solar radiations, wind speed, ambient temperature and temperatures at different points of the fabricated system were measured. The modules were mounted on a frame facing true south at the inclination of the latitude of the location. The measurements were taken during daytime with one hour intervals for two weeks. The temperatures at various points on cooled and un-cooled photovoltaic modules were noted using two different flow rates with 1 lit/min and 2 lit/min. It was discovered that the efficiency of PV module was enhanced from 6% to 7% during study period. The flow rate of 1lit/min was found more feasible for heat extraction as compared to the flow rate of 2lit/min. The wind speed was found to be more helpful for heat extraction from the modules as compared to other climatic parameters.
Authors and Affiliations
A. Q. Jakhrani, A. R. Jatoi, S. H. Jakhrani
Experimental Investigation of Influence of Acoustic Wave on Vapour Precipitation Process
The measurement results of acoustic field parameters above electroplating bath, in presence of water vapour, are analyzed in this work. Suction was created by means of side exhausters. It is obtained that the sound field...
Design of a Self-Phased Quadrifilar Helix Antenna for Satellite Communication
The objective of this study is the design and implementation of a Quadrifilar Helix Antenna (QHA) for telemetry, tracking and control of a Low Earth Orbit (LEO) satellite. Because of its cardioid-shaped circularly polari...
A Comparative Study of Construction Waste Generation Rate Based on Different Construction Methods on Construction Project in Malaysia
High construction waste (CW) generation in Malaysia has serious impacts although there are very little available data regarding the relevant issue in Malaysia. This lack of data results in improper CW management and CW d...
Water Availability in Snow Dominated Regions under Projected Climatic Variability: A Case Study of Alpine Catchment, Austria
This study analyzes the response of various hydrological parameters and future water availability against anticipated climate variations in snow dominated alpine catchment in Austria. The parameters assessed are base flo...
Statistical Modeling via Bootstrapping and Weighted Techniques Based on Variances
Multiple logistic regression is a methodology of handling dependent variables with a binary outcome. This method is becoming increasingly widespread as a statistical technique that represents a discrete probability model...