Analysis and optimization of the reactive power compensation modes in a power supply system
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2019, Vol 3, Issue 8
Abstract
<p>The paper reports the study of modes in a single-phase generalized power supply system in terms of improving energy indicators in the system by compensating for the reactive power. We considered three test versions of the power supply system with different ratios of complex load impedance and power lines. We show the drawbacks of the traditional method for calculating the parameters of the compensating device, which provide partial compensation of reactive power consumed only by the load. An analysis of the partial compensation mode indicates that with an increase in the reactivity of the transmission line, the energy indices, which can be obtained as a result of reactive power compensation, deteriorate. Using search engine optimization, it is shown that an increase in the capacity of the compensator is required for full compensation. The method of search engine optimization is implemented in the Mathcad software package using the given-find decision unit. For this purpose, we used the equations of the mathematical model of the power supply system based on component and topological equations. As additional conditions, we used relations that determine the reactive power of the supply source full compensation, as well as the conditions for the physical implementation of the compensating device structure. The optimization variables are the parameters of the mode under study and the parameters of the compensating device. Fragments of texts in the program with numerical solutions are presented, as well as comparative tables of analysis and optimization results of reactive power compensation modes in the studied power supply systems for all variants of their parameters. The quantitative estimates of additional capacity value are given, which is calculated based on the condition for the compensation of reactive power in the transmission line by it. Our study has shown that with an increase in the reactance of the transmission line, full compensation cannot be achieved with the use of shunt compensation and physical interpretation of this phenomenon. It implies that the voltage on the compensating shunt capacitor decreases faster than the reactive power of the transmission line compensated by it increases. It is shown that in the latter case, the full compensation of reactive power can still be achieved by using combined series-shunt compensation.</p>
Authors and Affiliations
Valeriy Yagup, Katerina Yagup, Yuliia Kovalova, Viktor Kharchenko, Tetiana Besarab, Oleksii Krasnov, Illya Domanskii, Vasilii Domanskii, Hennadii Kostin, Haidar Gafar AbuGoukh
Improvement of the installation with an extended barrel of cranked type used for fire extinguishing by gel-forming compositions
<p>Extinguishing fires with gel-forming compositions was found to be a promising direction of increasing the extinguishing efficiency, especially at multi-storey buildings and facilities for different functional purposes...
Determining the force function distribution in the working zone of a disk magnetic separator
The paper reports a research into the distribution of magnetic force function in the working zone of a newly-designed disk separator, intended to clean the finely-dispersed bulk substances, transported by a belt conveyor...
Studying the influence of design and operation mode parameters on efficiency of the systems of biochemical purification of emissions
<p>A procedure for evaluating efficiency of the systems of biological elimination of soluble and insoluble in water harmful gaseous substances as well as dissolved in water contaminants has been devised. The procedure is...
Effect of mechanoactivated chemical additives on the process of gas hydrate formation
<p>This study addresses the production of gas hydrate of methane with a high gas-hydrate-forming content in a solid phase in the isolated system at T=274 K and pressure of 5 MPa and presence of mechanically activated roc...
Geometric modeling of the unfolding of a rod structure in the form of a double spherical pendulum in weightlessness
<p>We investigated the geometric model of the new technique for unfolding a rod structure, similar to the double spherical pendulum, in weightlessness. Displacements of elements occur due to the pulses from pyrotechnic j...