Analysis of Cold Formed Sections of Steel Angle under Tensile Load by Numerical Method
Journal Title: GRD Journal for Engineering - Year 2018, Vol 4, Issue 1
Abstract
The effective sectional area concept was adopted to conduct the analysis of cold-formed Tension members. ANSYS software was utilized to simulate the behavior of cold formed steel angle under tension load. The paper describes the results from a finite element investigation into the load capacity tension members of single angle sections and double angles sections of 1.5 mm and 1.6 mm under plain (without Lipped) and with Lipped conditions subjected to tension. Results were recorded as the load carrying capacity increases for connected to the opposite side of the gusset than the connected to same side. It observed load vs deflection, Analyses are compared with experimental results.
Authors and Affiliations
A. Paulmakesh, Dr. S. Arivalagan
Keywords
Related Articles
- EP ID EP549960
- DOI -
- Views 102
- Downloads 0
Fuzzy Logic Based Power Factor Correction AC-DC Converter
A DC-link voltage is widely used in industrials and domestic’s application. Simple diode rectifier’s bridges are used to create dc voltage link. A diode rectifier has a high distortion input currents wave form and low po...
Analysis of Intze type Water Tank with Different Staging System & its Optimal Design
Water storage structures are used to store water to tide over the daily requirement of water by localities, industries, campuses, towns, cities, etc. Especially elevated water tanks are used to supply water to a particul...
Use of Water Quality Index Result of Robertson Lake Jabalpur in Remote Sensing Application
The water of Robertson Lake is suffering from severe contamination which is due to heavy discharge of pollutants without adequate treatment to remove harmful compounds. This is leading to the damaging effects not only to...
Fatigue Analysis of Bearing
The development of the technology of rolling bearings has as one of its objectives constitute a set of mechanical components that combine mechanical strength and stiffness, designed to support the loads, speeds and life...
Design and Implementation of Dual-Band Bandpass Filter using Tappered E Shaped Dual Mode Open Loop Resonator
In the Bandpass filter two open stepped impedance resonator is introduce with help of dual band pass filter. The proposed filter having an extra added two open stabbed impudence resonator in inside the substrate and the...