Analysis of Different Controllers for Controlling Buck Converter
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2016, Vol 4, Issue 6
Abstract
In this paper a Hybrid Controller is introduced i.e. PID-NN Controller (PID with neural network) for improving the output response of buck converter. Hybridization is somewhat, combining the advantageous part of both controllers together. Here, Buck converter’s Output voltage is controlled by different controllers and comparing results obtained from Controllers. Classical linear techniques have stability around the operating point. This Paper shows comparison of different controller’s response in order to control buck converter. The output response of Buck Converter is tested with different controllers individually & results are shown. Neural network technique used as gain scheduler that computes the values of Proportion (Kp), Derivative (Kd),& integral constant (Ki) values for PID Controller. PID output provides the change in duty ratio and then it applied to PWM block to produce the required duty cycle for Switch of Buck Converter. The objective is to improve the System’s output response under different load variations and also to use advantage of neural network such as strong learning ability and adaptability. All simulation are done at MATLAB/SIMULINK.
Authors and Affiliations
Lalit Kumar Sahu, Dushyant Singh
Integration of Solar Renewable Energy Source with Dynamic Wireless Power Transfer in Recharging IR Based Receivers
In the existing device, restricted strength at each node in Wireless Sensor Networks (WSNs) is understood to be the principal hurdle of their design and operation. Wireless power transmission continues to be in a resear...
Optimization of machining parameters in wire electrical discharge machine process by combination of genetic algorithm and artificial neural network
Wire electrical discharge machining (WEDM) has become an important non-traditional machining process. Wire Electrical discharge machining (WEDM) process, at present is still an experience process, wherein selected param...
Study of Dynamic State Routing Protocol (DSR)
Mobile Ad-hoc Network (MANET) is an infrastructure less, decentralized, network consisting of wireless mobile nodes which changes the topology dynamically. Because of dynamic change in the network topology, the routing...
Security Measures To Protect The Risk Management In The E-Voting Technology
The rapid evolution of Information and Communication Technology (ICT) in today’s world, However, prior to the implementation of remote electronic voting technology, one ofthe key issues that should be addressed is the s...
Data Transmission Using Barcode Modulation Technique
The concept of Barcode is of great relevance for use in wireless data transmission between hand held device . In a typical setup, any file on a cell phone, for example, can be transferred to a second cell phone through...