Analysis of HD Journal Bearings Considering Elastic Deformation and Non-Newtonian Rabinowitsch Fluid Model
Journal Title: Tribology in Industry - Year 2016, Vol 38, Issue 2
Abstract
The purpose of this paper is to study the performance of a finite length journal bearing, taking into account effects of non-Newtonian Rabinowitsch flow rheology and elastic deformations of the bearing liner. According to the Rabinowitsch fluid model, the cubic-stress constitutive equation is used to account for the non-Newtonian effects of pseudoplastic and dilatant lubricants. Integrating the continuity equation across the film, the nonlinear non-Newtonian Reynolds-type equation is derived. The elasticity part of the problem is solved on the base of Vlassov model of an elastic foundation. The numerical solution of the modified Reynolds equation is carried out by using FDM with over-relaxation technique. The results for steady state bearing performance characteristics have been calculated for various values of nonlinear factor and elasticity parameters. It was concluded that in comparison with the Newtonian lubricants, higher values of film pressure and load carrying capacity have been obtained for dilatant lubricants, while the case was reversed for pseudoplastic lubricants.
Authors and Affiliations
J. Javorova , A. Mazdrakova , I. Andonov , A. Radulescu
Keywords
Related Articles
- EP ID EP112459
- DOI -
- Views 110
- Downloads 0
Wear Assessment of Fe-TiC/ZrC Hardfacing Produced from Oxides
The direct conversion of oxides into carbides during plasma transferred arc welding is a promising processing route to produce wear resistant overlays at low cost. In the present study, Fe-TiC and Fe-ZrC composite overla...
A New Method for the Analysis of Misaligned Journal Bearing
One of the most problems that affects the performance of the journal bearing is the shaft misalignment. Misalignment may result due to installation error, shaft deformation, manufacturing error, bearing wear, etc. This p...
Research Regarding the Anticorosiv Protection of Atmospheric andVacuum Distillation Unit that Process Crude Oil
Due to high boiling temperature, organic acids are present in the warmer areas of metal equipment from atmospheric and vacuum distillation units and determine, increased corrosion processes in furnace tubes, transfer lin...
Neural Network Modeling of Cutting Fluid Impact on Energy Consumption during Turning
This paper presents a part of research on power consumption differences between various cutting fluids used during turning operations. An attempt was made to study the possibility of artificial neural network to model th...
Aplication of Atomic Force Microscope for Mechanical and Tribological Characterization of Teeth and Biomaterials
This paper describes analysis of mechanical and tribological properties of human teeth and of their restorative materials by use of the atomic force microscope (AFM) and its combination with nanoidentation. By use of the...