Analysis of radiation resistance control and evaluation methods in terms of model (Zn-O)-GaP LEDs Introduction and problem statement
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2014, Vol 0, Issue 56
Abstract
Introduction and problem statement. Research relevance of most important parameters of LEDs — resistance to ionizing radiation — for their use in civilian hardware, aerospace, nuclear and radioelectronics onboard equipment is shown. Samples and experimental technique. Samples obtaining method for studying of neutron irradiation influence on the LEDs is indicated. The neutron irradiation influence on the basic characteristics (light intensity) given current and voltage is investigated. Experimental results interpretation shows that for this model current radiative component associated with electrons injection in the optically active p-region. Radiative excitons recombination occurs at the (Zn-O)-complexes, the concentration of which is a linear function. An experimental study light intensity dependences of fluens and damage constant finding. Theoretically and experimentally investigated the light intensity dependence of neutron irradiation fluens at given current. The (IV0/IV) dependencies from fluens neutrons with energy >= 0,1 MeV and fixed voltage of 1,65 V is presented. It shown that light intensity reduction while irradiation at the fixed current is much faster than at the fixed voltage. The calculation formula and (IV0/IV) dependence from neutrons fluens for set of 25 LEDs at nominal current 10 mA are received. Conclusions. The neutron irradiation influence with energy above 0,1 and 2,65 MeV on the light intensity red glow (Zn-O)-LEDs is indicated. It shown that damage constant is proportional to the neutrons momentum. The calculated light intensity dependence from fluens at given current is received.
Authors and Affiliations
O. Abdullaiev, I. Ryzhikov, N. Rudenko, Yu. Adamenko
Analysis of the behavior of the Lyapunov function in the optimization of analog circuits
The process of optimization of analog circuits is defined mathematically as the dynamic controllable system. Thus the problem of minimization of processor time can be set forth as a task of minimization of time of transi...
Vitally of the engineering education
Engineering education (working majors, higher school) is responding in large degree for the level of profession census of nation. In 21st century technological component and enhancing economics globalization make an actu...
Research of ambiguity function of discrete frequency sequence «Welch-16»
Ambiguity function of a discrete frequency signal in which the number sequence «Welch-16» as frequency coding sequence is used is considered
Criteria as a route to the routing algorithm in mesh networks with reduced interference
The paper presents the development assessment system tracks peredichi information in the mesh network and routing algorithm that uses data evaluation. Using this algorithm reduces the interference in the network and po...
Adaptive signal detection on the background clutter
Introduction. The article poses the problem of optimal detection of coherent-pulsed signals of moving targets against a background of clutter with a priori uncertainty of the signals and clutter parameters. The aim of th...