ANALYSIS OF THE CHOSEN ATTRIBUTES OF DIFFERENT TYPES OF LUXMETERS
Journal Title: Proceedings of Electrotechnical Institute Prace Instytutu Elektrotechniki - Year 2015, Vol 62, Issue 268
Abstract
An iluminance meter is the basic and most frequently used measuring instrument in photometry. This instrument must meet a number of requirements e.g. a spectral and space correction of the photoelement in order to have the illuminance corresponding to the actual value. In the recent years, more and more photometers can be found on the market, which have generated a lot of attention because of their low price. Their individual cost is very often lower than the calibration price. On the grounds of the performed laboratory measurements, the chosen metrological attributes of commonly used luxmeters during the indoor verification of lighting parameters were analysed in the article. Instruments of high as well as low accuracy were tested. During the indoor lighting the light sources of different spectral concentration are used. Concerning this fact the individual luxmeters read-outs with light-sensitive surfaces lighted by the discharge lamp as well as LED sources were registered. Obtained results were compared with the values received during measurements carried out with the use of an electric lamp of the colour temperature T[sub]c[/sub] = 2856 K, i.e. a source, which radiation is used during the calibration of photometers. The relative and cosine errors as well as the colour correction coefficients (factors) were set down based on the carried out measurements. They were complemented with the registration of the spectral concentration locus of the light sources used during the experimental measurements.
Authors and Affiliations
Agnieszka Banaszak, Przemysław Tabaka, Justyna Wtorkiewicz
Keywords
Related Articles
- EP ID EP68521
- DOI -
- Views 88
- Downloads 0
PRACTICAL ASPECTS OF SHORT-CIRCUIT WITHSTAND OF THE POWER SEMICONDUCTOR DEVICES
Short-circuit withstand of electric power system equipment is a part of the tests carried out by Institute of Power Engineering in Warsaw. In this article we have gathered our experience gained during the research of the...
WPŁYW TECHNOLOGII HAPTYCZNEJ NA JAKOŚĆ STEROWANIA W URZĄDZENIACH MECHATRONICZNYCH
Autorzy przedstawili w artykule konstrukcje dwóch urządzeń mechatronicznych: manipulatora oraz pojazdu inspekcyjnego. Do sterowania zastosowano dżojstik z dwoma stopniami swobody. Całość wykonano, używając do budowy posi...
TECHNIKI SZYBKIEGO PROTOTYPOWANIA ELEKTROMECHANICZNYCH PRZETWORNIKÓW ENERGII
Projektowania elektromechanicznych przetworników energii elektrycznej obejmuje trzy etapy: analizę teoretyczną, modelowanie i badania symulacyjne oraz implementację i badania w warunkach laboratoryjnych. Współpraca układ...
DYNAMIC REACTIVE POWER COMPENSATION WITH THE USE OF 1-PHASE ACTIVE POWER FILTER
A certain group of electrical power loads consumes fast time-varying reactive power. To this group belong office circuits containing computers. This circuit gets the reactive power with high dynamic changes at the level...
CERAMICZNE PRZEWODNIKI SUPERJONOWE DO ZASTOSOWANIA W URZĄDZENIACH ELEKTROCHEMICZNYCH
Przewodniki superjonowe charakteryzują się dużą przewodnością jonową, co predysponuje je do zastosowań w urządzeniach elektrochemicznych takich jak: ogniwa paliwowe, elektrolizery, czujniki i pompy tlenu. Niniejsza publi...