Analysis of the dynamic state of the system "fixture – workpiece"
Journal Title: Журнал інженерних наук - Year 2016, Vol 3, Issue 1
Abstract
In this article the vibrations of the “fixture – workpiece” system arising during the cutting process at various manufacturing steps under machining of levers in different fixture systems were investigated by means of numerical simulation methods. The workpieces from different materials were investigated during modeling. The results of harmonic analysis showed that the dynamic stiffness of modular adjustable fixture is higher than the stiffness of the dedicated fixture and the modular fixture. The amplitude of the vibrations in the points of machining surfaces in the modular adjustable fixture does not exceed the tolerances on the manufacturing of lever.
Authors and Affiliations
V. Ivanov, I. Pavlenko, Y. Rong
Keywords
Related Articles
- EP ID EP241675
- DOI -
- Views 113
- Downloads 0
Investigation of produced waters radioactivity of oil and gas deposits in the Dnieper-Donets province
The process of radioactive pollution of produced waters, oilfield equipment, oil-contaminated soils and sludge is widely spread and differs within the various oil and gas regions. Formation waters contained radioactive e...
Comprehensive Approach for Identification of Nonlinear Stiffness Characteristics of Bearing Supports for the Oxidizer Turbopump of the Liquid Rocket Engine
This article dials with the refinement of the mathematical and computational models of the oxidizer turbopump rotor considering bearing gaps, axial preloading, compliance of the housing parts and the effect of rotation....
Influence of an Inlet Rotating Axial Device on the Cavitation Processes in a Low Specific Speed Centrifugal Pump
The paper is devoted to the analysis of the cavitation processes in the flow section of the low specific speed centrifugal pump. A new conception of double-entry hermetic pump leads to the application of special shaped i...
Experimental simulation of diamond grinding of internal sphere in sapphire
Insufficient crack growth resistance and durability of sapphire or ceramic materials are essential short coming which complicates their application in total human arthroplasty. One possible approach of elimination of thi...
Deletion method of image low-frequency components using fast median filter algorithm
This article proposes a computational method for removing low-frequency component of the raster image. Development of a calculation method is based on the fast median filtering. Presented method implementation removes lo...