Analytical description of the expansion of wall jets of different curvature
Journal Title: Вентиляція, освітлення та теплогазопостачання - Year 2019, Vol 29, Issue
Abstract
The work is devoted to an analytical study of the expansion of wall jets on a convex and concave surfaces (curved semi-limited jets). Such jets have different characteristics depending on the curvature of the surface - from long-range to fast-decay. This makes them one of the most promising areas of increasing the efficiency of air exchange in rooms for various purposes. However, today they have not widespread introduction, which is because of the instability of the development of the jets. The problem is eliminated by using the correct shape of the air outlet duct. To determine the expansion of the jet, an approach has been developed to the analytical description of curved wall jets using the geometric analysis of their turbulent macrostructure. This structure is represented in the form of a sheet of tangent large-scale vortices (puffs). To effectively solve the obtained equations, the Anderson-Björk method was improved. The results show a slight expansion of concave jets and much faster for convex ones. Calculations showed the presence of a critical section with the rapid expansion of a convex jet and the subsequent increased rate of its expansion. Also, a cross section for separation of the jet is obtained. If the slot width is less than 0.15 ... 0.2 of the radius of the wall, then the angle of passage of the jet is significantly reduced, which reduces the expansion of the jet and complicates the design of the multi-slot air distributors developed at the Department of Heat and Gas Supply and Ventilation of Kiev National University of Construction and Architecture.
Authors and Affiliations
V. Mileikovskyi
Keywords
Related Articles
- EP ID EP648498
- DOI -
- Views 72
- Downloads 0
Simulation and optimization of heat-exchanger parameters by the methods of non-equilibrium thermodynamics
The results of computational (numerical) simulation and optimization of constructive and secure characteristics of the heat-exchanger devices – heat utilizer of a type «liquid-gas» are presented at work.The minimal gener...
Combustion of Low Grade Solid-Fuel of Autonomous and Decentralized Heat Supply System in a Heat Generator
The expediency of using a municipal energy of solid fuel of different quality in heat generators: from high-grade low-ash to low-grade, which is characterized by high humidity and ash content is explained. The negative i...
An Analytical Study of the Efficiency of the Natural General Ventilation of Cattle Building
Operating costs for the work of general ventilation systems is about 30 % in the energy balance of premises for keeping cattle. The possibility of increasing the efficiency of general ventilation of the premises for keep...
Investigation of the Efficiency of the Application of Water Solution of Lexol Reagent for Preparation of Pulling
A study of the effectiveness using the aqueous solution of the surfactant "Lexol" for dust suppression during mass explosions in quarries, on technological highways and use as an anti-freezing agent during transportation...
A Method for the Analysis of Isotherms, Surface Fractal Dimension and Dynamic Chaos of Moisture Exchange in Colloidal Capillary-Porous Museum Exhibits at Changeable Microclimate Conditions
On the basis of sorption-desorption isotherms in colloidal capillary-porous bodies (CCPT), their surface fractal dimension was calculated and its spatial-temporal changes were investigated. The physic-chemical and rheolo...