Analyzing an error in the synchronization of hydraulic motor speed under transient operating conditions
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2019, Vol 4, Issue 7
Abstract
<p>A hydraulic drive with two hydraulic cylinders was considered in which the rod movement speeds are synchronized by a divider of the working fluid flow. Based on the developed mathematical model, operation of synchronized hydraulic cylinders in transient operating conditions with a sudden change of load on one of the hydraulic cylinders was calculated. Speeds of movement of the hydraulic cylinder rods and pressures in the inter-throttle chambers of the flow divider were determined. It was established that there were variations of pressure in the inter-chamber chambers of the flow divider in the transient conditions of operation of the drive caused by a sudden change of load on the hydraulic cylinders and, as a result, an error of synchronization of speed of movement of the cylinders rods appeared at the initial stage. Relative pressure differential in the inter-throttle chambers reached 1 and the relative difference of speeds of movement reached 0.43. To improve accuracy of synchronization of hydraulic motor movement, a flow divider was proposed with an additional feedback in the pressure differential in the inter-throttle chambers of the divider. The additional feedback was realized through the use of a double-slotted throttling distributor of the spool-valve type. Proceeding from the conditions of a minimum synchronization error, the necessary dependence of change of area of the working slot of the controlled throttles was determined and recommendations on profiling the working slots of the spool throttle were given.</p><p>It was established by calculation and confirmed experimentally that the use of controlled throttles reduces the error of synchronization of speed of movement of the cylinder rods to 0.27 and the pressure differential in the inter-throttle chambers of the flow divider to 0.53.</p><p>Harmonics of higher order occurred in a transient process for speed and pressure. They were caused by movement of the spool valve of the double-slot distributor.</p><p>Presence of harmonics of higher order in variations of pressure and velocity did not significantly affect operation of hydraulic motors since amplitude of these variations was negligible.</p><p>Reduction of the speed synchronization error is due to simultaneous change of area of the throttle which stabilizes pressure differential and the area of the controlled throttle.</p>
Authors and Affiliations
Oleksii Havrylenko, Serhii Kulinich
Keywords
Related Articles
- EP ID EP666902
- DOI 10.15587/1729-4061.2019.175033
- Views 69
- Downloads 0
Welded joints geometry testing by means of automated structured light scanning
<span lang="EN-AU">Nuclear industry in Russia plays an important role in total power generation. At the same time, it is considered to be dangerous in terms of high potential risk in a case of any failure occurrence. The...
Determining the regions for efficient use of electrojet lowthrust engines
<p>This work addresses the issues on determining the optimal regions for using propulsion system for spacecraft at low near-Earth orbits. An analysis of spacecraft launches over the past 5 years has been performed. The r...
Developing the method of rational trucking routing based on the modified ant algorithm
<p>The method of rational routing based on the modified ant algorithm with introduction of a quality function that characterizes the qualitative state of roads was proposed. Comprehensive assessment of potential routes t...
Experimental study of cavitation destruction of a protective composite polyurethane-based material
<p class="Journals-title">Studying the process of cavitation has remained relevant up to now. The reason for this is the multifactorial causes of cavitation and, as a result, the difficulty to prevent it. One effective w...
Investigation of the process of smoothing with ultrasound
<p>We studied and simulated the ultrasonic smoothing process. We carried out the analysis of the contact interaction of a tool with a part in the process of ultrasonic smoothing with a preceding gap. The analysis provide...