Automatic Solar Tracker with Dust Wiper Using PID Controller
Journal Title: International Journal of Trend in Scientific Research and Development - Year 2017, Vol 2, Issue 1
Abstract
The Earth receives 174 peta watts (PW) of incoming solar radiation at the upper atmosphere. Approximately 30% is reflected back to space while the rest is absorbed. Solar energy is an alternative for fossil fuels as it is non-polluting, clean, reliable and renewable source of energy. It does not pollute the air by releasing harmful gases like carbon dioxide, nitrogen oxide or sulphur oxide. So, the risk of damage to the environment is reduced. Thus the use of solar devices was more suggested and the traffic signal and street lights in villages was installed using solar panel but the solar PV modules are generally employed in the dusty environments and the dust gets accumulated on the front surface of the module and blocks the incident light form the sun and it reduces the power generation capacity of the module, the power output reduces if the module is not cleaned for a regularly. In order to regularly clean the dust, this research presents a control application of a sun tracker that is able to follow the sun with high accuracy and clean the dust on the panel without the necessity of either a precise procedure of installation or recalibration. The designed tracking system consists of sensors, microcontroller, drivers for dc motors and gear- bearing arrangements with supports and mountings. DC motor is used to move the system panel so that suns beam is able to remain aligned with the solar panel and also clean the dust on the panel which improves the efficiency of the solar panel. Simulation and experimental results are obtained to a low cost single axis solar tracker and are exposed. Energy saving factors are taken into account, which implies that, among other factors, the sun is not constantly tracked with the same accuracy, to prevent energy over consumption by the motors. Kavya S Gogi | Maheshan CM | H Prasanna Kumar"Automatic Solar Tracker with Dust Wiper Using PID Controller" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-2 | Issue-1 , December 2017, URL: http://www.ijtsrd.com/papers/ijtsrd7197.pdf http://www.ijtsrd.com/engineering/automotive-engineering/7197/automatic-solar-tracker-with-dust-wiper-using-pid-controller/kavya-s-gogi
Sentiment Analysis of Feedback Data
Knowing about the user’s feedback can come to a greater aid in knowing the user as well as improving the organization. Here an example of student’s data is taken for study purpose. Analyzing the student feedback will...
Development and Characterization of Cardanol Based Polymer Reinforced Fibre Bicomposites
The emerging quest for optimal use of naturally obtained resources through advanced technigues and products has escalated research and exploration of naturally oriented renewable materials. In present investigation, card...
Emerging Trends of Remote Learning in the Higher Education Challenges and Opportunities after COVID 19 Situation
The COVID 19 pandemic has not only affected higher education on a global scale, but it has also brought numerous challenges to the higher education community. Remote learning refers to situations where learners and lectu...
Design and Analysis of Crane Hook with Different Materials
Cranes are industrial machines that are mainly used for materials movements in construction sites, production halls, assembly lines, storage areas, power stations and similar places. A hook is a tool consisting of a leng...
Efficacy of rice-stubble allelochemicals on vegetative growth parameters of some oil-yielding crops
"A laboratory experiment was conducted to investigate allelopathic potential of water extract of rice-stubble leachate on certain oil-yielding crops mustard, sesamum and sunflower . A wide range of rice-stubble concentra...