Automatization in road transport: a review
Journal Title: Production Engineering Archives - Year 2018, Vol 20, Issue
Abstract
In this article automatization of road transport is investigated. In the first chapter relevant international trends were identified. In this paper the research hypothesis is that in the case of automatized road vehicles there is a significant likelihood of endangering human life. Secondly, the history of road safety is shortly described, especially focusing on vehicle design and sweep of system’s theory. In the third chapter evolution of drivers’ assistance systems were elaborated, emphasizing especially autonomous vehicles. Finally, in conclusion the authors warn that new technological solutions could pose new threats.
Authors and Affiliations
Tadej Derenda, Marina Zanne, Mate Zoldy, Adam Torok
Keywords
Related Articles
- EP ID EP489005
- DOI 10.30657/pea.2018.20.01
- Views 81
- Downloads 0
Management aspects of the heating system work
The article discusses the problems of optimization and management of a centralized heating system. It characterizes the heating systems and the process of heat supply. The work focuses on identifying the components of th...
How can people be convinced to buy electric cars? – case of Slovenia
Electric cars represent a promising energy-and carbon-efficient alternative to internal combustion en-gine cars. However, as mobility behaviour is highly habitual, convincing people to switch from con-ventional cars to e...
Quality education enhancement by means of university environmental edification
The submitted work partly describes the historical and actual trends of the introduction of targeted environmental edification at universities based on the framework of Slovakian sustainable development as well as its en...
Applying the 5 Why method to verification of non-compliance causes established after application of the Ishikawa diagram in the process of improving the production of drive half-shafts
The automotive industry is one of the most important branches of the global industry. For this purpose, products are produced by an extensive network of suppliers. They supply components directly to the (OEM - Original E...
Microstructural evaluation of the lacquered layer quality after corrosion load
Surface pre-treatment is one of the most important steps before applying the final surface treatment. These pre-treatments, like phosphating, alkaline degreasing, pickling in acids, is used to remove impurities from the...