BOUNDARY ELEMENT METHOD AND SET LEVEL METHOD IN ELECTRICAL DIFFUSE TOMOGRAPHY

Abstract

In this paper was presented coupling Boundary Element Method and Set Level methods for identification of unknown shape of interface in electrical impedance tomography (EIT). It’s shown how determinate velocity, how extend it, how use it to move interface and finally how to reset level function. Finally the example showing identification of three areas of heterogeneous sample, using multi zero levels function is presented.

Authors and Affiliations

Bartosz Waleska, Jan Sikora

Keywords

Related Articles

COMPLEX-HARMONIC ANALYSIS OF ELECTRIC CIRCUIT CONTAINING A VIBRATING-PLATE CAPACITOR

A complex-harmonic analysis technique was used for mathematical analysis of electric circuit containing a vibrating-plate capacitor. An equation for the transducer function of such a circuit is obtained. Amplitude and p...

THE REVIEW OF SELECTED ELECTRICAL ENERGY STORAGE TECHNIQUES

The article contains basic information about selected mechanical, electrical and electrochemical techniques of electrical energy storage. Due to the rising popularity of renewable resources, electrical energy storage sys...

ANALYSIS OF DISTURBANCES IN ELECTRIC POWERS SYSTEMS CAUSED BY LIGHTNING DISCHARGES

This paper deals with analyzing specific transient states of voltages in electric power systems of high voltages. The paper presents the results of the analysis of operational disturbances caused by lightning discharges...

THE DESIGN OF READOUT FRONT-END ELECTRONICS FOR TIME AND ENERGY MEASUREMENTS FOR SEMICONDUCTOR STRIP DETECTORS

This work presents the design of the readout front-end electronics for time and energy measurements dedicated for double-sided strip detectors implemented in submicron technology UMC 180 nm CMOS. The simultaneous and acc...

CONTROL AND GRID SYNCHRONIZATION OF TWO LEVEL VOLTAGE SOURCE INVERTER UNDER TEMPORARY VOLTAGE UNBALANCE

This paper presents the operation of grid tied, two level voltage source inverter (VSI) during network voltage unbalance. The control system was implemented in synchronous rotating reference frame dq0 (SRF). Two types of...

Download PDF file
  • EP ID EP59362
  • DOI -
  • Views 161
  • Downloads 0

How To Cite

Bartosz Waleska, Jan Sikora (2012). BOUNDARY ELEMENT METHOD AND SET LEVEL METHOD IN ELECTRICAL DIFFUSE TOMOGRAPHY . Informatyka Automatyka Pomiary w Gospodarce i Ochronie Środowiska, 2(4), 3-6. https://europub.co.uk/articles/-A-59362