Breast Cancer Classification using Global Discriminate Features in Mammographic Images
Journal Title: International Journal of Advanced Computer Science & Applications - Year 2019, Vol 10, Issue 2
Abstract
Breast cancer has become a rapidly prevailing disease among women all over the world. In term of mortality, it is considered to be the second leading cause of death. Death risk can be reduced by early stage detection, followed by a suitable treatment procedure. Contemporary literature shows that mammographic imaging is widely used for premature discovery of breast cancer. In this paper, we propose an efficient Computer Aided Diagnostic (CAD) system for the detection of breast cancer using mammography images. The CAD system extracts largely discriminating features on the global level for representation of target categories in two sets: all 20 extracted features and top 7 ranked features among them. Texture characteristics using co-occurrence matrices are calculated via the single offset vector. Multilayer perceptron neural network with optimized architecture is fed with individual feature sets and results are produced. Data division corresponds as 60%, 20%, and 20% is used for training, cross-validation, and test purposes, respectively. Robust results are achieved and presented after rotating the data up to five times, which shows higher than 99% accuracy for both target categories, and hence outperform the existing solutions.
Authors and Affiliations
Nadeem Tariq, Beenish Abid, Khawaja Ali Qadeer, Imran Hashim, Zulfiqar Ali, Ikramullah Khosa
Keywords
Related Articles
- EP ID EP468610
- DOI 10.14569/IJACSA.2019.0100250
- Views 62
- Downloads 0
Linear Prediction Model for Effort in Programming based on User Acceptance and Revised use Case Point Method
As long as most of the processes of verification and validation of software to grant acceptance by the customer/user, are subjective type, it is aimed to design a standard mathematical model with empirical to perform an...
Active and Reactive Power Control of Wind Turbine based on Doubly Fed Induction Generator using Adaptive Sliding Mode Approach
In this work, a robust Adaptive sliding mode controller (ASMC) is proposed to improve the dynamic performance of the Doubly Fed Induction generator (DFIG) based wind system under variable wind speed conditions. Firstly,...
BRIQA: Framework for the Blind and Referenced Visual Image Quality Assessment
Our proposal is to present a Blind and Referenced Image Quality Assessment or BRIQA. Thus, the main proposal of this paper is to propose an Interface, which contains not only a Full-Referenced Image Quality Assessment (I...
Modeling and FPGA Implementation of a Thermal Peak Detection Unit for Complex System Design
This paper, presents the modelization and the implementation of a thermal peak detection unit for complex system design. The modelization step starts with modeling the formula of the heat source using Simulink/Matlab too...
XCS with an internal action table for non-Markov environments
To cope with sequential decision problems in non- Markov environments, learning classifier systems using the internal register have been proposed. Since, by utilizing the action part of classifiers, these systems control...