Buckling Analysis of Laminated Composite Plates using Layer Wise Higher Order Shear Deformation Theory
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2017, Vol 7, Issue 5
Abstract
This paper represents the investigation on the response of symmetric laminated composite plate. In this paper, an attempt is made to study the Buckling characteristics of a laminated composite plates, using layer wise HSDT. Buckling is one of the major modes of failure of laminated structures and it is necessary to predict the critical load of the structural component, for the easy replacement with good load bearing capacity. Studying buckling characteristics of laminated composite plates is essential, in order to have a deep insight of their behaviour for proper analysis and design. The derivation of equations of motion for layer wise higher order models is obtained, using the virtual work principle. Further, the analytical solutions are developed to find buckling characteristics of laminated composite plates. The solution predicts critical buckling load of laminated composite plate. The results obtained by using the present model are compared with the available literature.
Authors and Affiliations
S. Lokesh, GS Vivek, L. Praveen
Keywords
Related Articles
- EP ID EP245022
- DOI -
- Views 110
- Downloads 0
Effect of Alkali Treatment on Tensile/Chemical Properties and Dielectric Strength of Bamboo and Grass Fiber Reinforced Polyester Composites
Bamboo and Grass fiber reinforced polyester hybrid composite material was fabricated using the rule of mixtures. The tensile and chemical properties of this composite were studied. The alkali treatment effect of the bamb...
Steady State Thermal Analysis of Continuous Variable Transmission with Extended Surfaces
A Continuous Variable Transmission is an unconventional type of transmission which transmits torque/power from the crankshaft of the engine to the wheels that run on the ground. It is a single speed step- less transmissi...
THE COMPUTATION OF STIFFNESS DERIVATIVE FOR AN OGIVE IN THE HYPERSONIC FLOW
Expression for Stiffness derivative for an Ogive is derived with the suppositions of the arc on the nose of the cone from the air is being considered as perfect gas and the viscosity being neglected, the motion is quasi-...
Design and Analysis of Wheel Head in Cutter and Tool Grinder
The work is entirely about “Design and Analysis of Wheel Head in Cutter and Tool Grinding Machine “. Wheel Head is a major part of a grinding machine, which consists of Various sectioned components, namely the wheel head...
Structural Optimization of Lathe Machine Bed
In this paper, a machine bed is chosen for the entire investigation, for both static and dynamic burdens. At that point, examination is completed to decrease the heaviness of the machine bed, without falling apart its ba...