CALCULATION OF CYLINDRICAL PRODUCTS MADE OF COMPOSITE MATERIALS USING WRAP TECHNOLOGY
Journal Title: Journal of Mechanical Engineering Research & Developments (JMERD) - Year 2019, Vol 42, Issue 2
Abstract
The paper has developed the calculation method of composite structure design according to wrap technology, the main results have been achieved: (i) – Constructing a mathematical model of composting tank under pressure of two sealed cylindrical layers by “grid method” with the following solutions: All tensile loads absorbed by the fibers, the tensile strength of the substrate in composite materials can be ignored; Composite shell is a non-torque shell with a relative thickness within the limits: ; Stress on all fibers everywhere, at any point of the surface, is constant or durable shell is uniform; and (ii)- The applied mathematical model to calculate structural parameters of fabrication of water filter.
Authors and Affiliations
Tran Thi Thanh Van, Tran Ngoc Thanh, Phạm Ngoc Vuong, Nguyen Duong Nam
Keywords
Related Articles
- EP ID EP503670
- DOI 10.26480/jmerd.02.2019.76.78
- Views 69
- Downloads 0
A STUDY ON THE FACTORS AFFECTING THE FLARE OF THE WELD WHEN WELDING THE STEEL WIRE
In this study, an equation for adjusting the parameters affecting the flare of the weld on the welding product was established. Based on the empirical research results, the factors affecting welding flux after using bend...
A RESEARCH ON MARINE DIESEL ENGINE SPEED CONTROLLER BY FUZZY LOGIC CONTROL THEORY BASED ON EXPERIMENTAL INVESTIGATION
The marine diesel engine speed automatic controller has an important mission in the field of keeping the setting speed constantly in the variable sea environment. Before, the conventional PID (Proportional – Integral – D...
PSEUDO ELASTIC METHODS FOR DAMAGE ASSESSMENT OF COMPOSITE TUBES
Rapid urbanization globally has led to increased traffic congestion within cities which often result in low speed collisions. These low speed collisions can happen during parking of Vehicles also. Bumpers provided for th...
INVESTIGATION ON THE MECHANICAL PROPERTIES OF PLA & ITS COMPOSITE FABRICATED THROUGH ADVANCED FUSION PLASTIC MODELLING
Advanced Fusion plastic modelling (AFPM) based rapid prototyping (RP) technique was emerged as one of the potential Technologies for serving numerous three-dimensional product for tool design purposes. Primarily, Poly La...
THE FAULT LOCATING SYSTEM OF THE HIGH-SPEED MAGLEV TRAIN
Analyzing and researching the levitation and guidance sensor fault location system of high-speed maglev train, we developed an offline testing method of sensor fault location system, which can carry on the fast positioni...