Characterization of Subsurface Using Schlumbeger Electrical Resistivity Method and Dynamic Cone Penetration Tests
Journal Title: Journal of Geography, Environment and Earth Science International - Year 2017, Vol 13, Issue 3
Abstract
Geophysical and Dynamic Cone Penetrometer Test (DCPT) were conducted at a site to characterize the subsurface as part of a near surface studies designed to determine the strength properties of the soil for a building foundation design. 1-D resistivity method involving the Schlumberger array was carried out at the proposed building site. Soil strength properties and grain size distribution were obtained by DCPT and laboratory analysis of soil samples respectively. Qualitative interpretation of the resistivity data suggested an A- type curve (where layer resistivity; ρ1<ρ2<ρ3), showing increasing resistivity with depth. The layer boundaries were not well defined due to poor resistivity contrast between the layers at depth. A 2-layer earth model is suggested with the average resistivity values ρ1 of 521.76 ohm-m and ρ2 of 819.94 ohm-m topping a bottom layer of a higher resistivity ρ3. Qualitative interpretation of the soundings estimated the first and second layer boundaries at 5 m and 10 m below ground respectively. Correlation of resistivity values with characteristic soils resistivity suggested a material composed of clayey, silt on the surface and sand with admixture of gravel and cobbles dominant at depth which accounted for the high resistivity. Conductive moist clay on top could account for the low resistivity values. DCPT results showed an increase in average bearing capacity from 300 to 500 kPa, to the depths of 1-2 m and decreasing from 250 to 160 kPa from 4-5 m, this suggested that the survey area is characterized by a relatively thin (1-2 m) competent top formation overlying non-cohesive materials. The non-cohesive material correlated with increasing resistivity values with depth from 4m below ground surface. These methods discussed have suggested alternatives to the more expensive and time consuming procedures of soil characterization, as well as provide preliminary field data to limit the number of confirmatory drill holes in site investigations.
Authors and Affiliations
S. O. Nyako, Festus Anane Mensah, Bernard Ofosu, Kwabena Opuni, Kwame Sarpong
Keywords
Related Articles
- EP ID EP321420
- DOI 10.9734/JGEESI/2017/33250
- Views 79
- Downloads 0
Sediment Transfer Variation Approach at Large Rural Watersheds Scale of Northern France
In the French “Nord-Pas-de-Calais” region, sediments suspended in runoff waters coming from rural watersheds play a major part in the turbidity of surface waters, silting up of streams, and silting of permanent structure...
Qualitative Interpretation of Recently Acquired Aeromagnetic Data of Naraguta Area, North Central Nigeria
This study on Qualitative Interpretation of recently acquired aeromagnetic data of Naraguta, sheet 168 was aimed at analysing and interpreting the data, identifying the subsurface structures and the mineralized zones. Us...
2-D Electrical Resistivity Survey for Cassiterite Potential Mapping in Jos-Bukuru Area, North Central, Nigeria
Aim: To use 2-D Electrical Resistivity method in Cassiterite Potential mapping in Jos-Bukuru Area, North Central, Nigeria. Methodology: Locations suspected to have very high probability for cassiterite mineralisation fr...
Mapping Groundwater Quality Parameters Using Geographic Information System (GIS) in Oyo State, Nigeria
The knowledge of spatial pattern of groundwater quality is important to ensure a holistic approach to the management of the resource quality status in space and time. Thus a sample each of underground water was collected...
Comment on “An Indication of Intentional Efforts to Cause Global Warming and Glacier Melting” by J. Marvin Herndon
Aims: This is a critical comment on the recently published paper by Herndon (JGEESI 9(1): 1-11, 2017). I present compelling findings that Herndon’s main claim that the “air-drop material” found on February 14, 2016 in Ha...