Cleaning and disposal of gas emissions from the production of calcinated soda ash
Journal Title: Журнал інженерних наук - Year 2017, Vol 4, Issue 2
Abstract
The article is devoted to the issues of reducing the negative impact on the environment of the production of soda ash, which is achieved by reducing the formation of gas and dust emissions, as well as their deeper cleaning. The problem of cleaning gas emissions from the production of soda ash is solved by using hollow vortex devices, their comparison with operating apparatus is given. The advantages of multi-stage vortex-type apparatuses for cleaning large volumes of industrial gas emissions are noted. The article states that the task of cleaning of industrial gas emissions is significantly complicated by their large volumes, which makes it difficult to use traditional treatment equipment. Most of the devices currently used to clean gases from gaseous, liquid and solid impurities are characterized by low throughput due to small maximum permissible gas velocities in the apparatus. The necessity of using multistage vortex devices for cleaning gas emissions from ammonia and soda dust is substantiated. The advantages of the apparatus of this group are noted - low hydraulic resistance, high efficiency and low energy and metal capacity. The comparison of vortex devices with other active gas cleaning devices according to fractional efficiency is given. The scheme of purification of gas emissions from soda dust, with its further utilization, is proposed. The efficiency of submicron particle deposition in a vortex apparatus with intensive phase interaction may exceed 95 %.
Authors and Affiliations
V. Moiseev, E. Мanoilo, A. Hrubnik, M. Vasyliev, D. Davydov
Keywords
Related Articles
- EP ID EP248648
- DOI 10.21272/jes.2017.4(2).b1
- Views 56
- Downloads 0
The impact of multi-gap seals on rotor dynamics
The research relevance of multi-slotted seals is of practical significance for increasing vibration-reliability of centrifugal pumps. This paper presents the model of a single-disk rotor with seals. The forced radial rot...
Creating a simulation model of software testing using Simulink package
The determination of the solution model of software testing that allows prediction both the whole process and its specific stages is actual for IT-industry. The article focuses on solving this problem. The aim of the art...
Comparison between PID and Artificial Neural Networks to Control of Boiler for Steam Power Plant
This paper presents is to develop and compare neural network and conventional based controllers for a boiler of steam power plant. Designs of two different controllers for pressure and temperature are presented for keepi...
Modelling of Separation and Air Classification Processes of Aerodisperse Systems in the Shelving Device
The following paper considers the process of classification of polydisperse free-flowing material according to granulometric composition using a gravitational air classificator. There were considered the problems of the...
Development of curvilinear blade impeller of vortex pump based on numerical simulation
The present paper focuses on study of relation between impeller outlet width and the slope of characteristic curve. In order to figure out this relation on the different operation modes the numerical simulation was used....