CNTs, Al2O3 and SiO2 Reinforced Epoxy: Tribological Properties of Polymer Nanocomposites
Journal Title: Tribology in Industry - Year 2017, Vol 39, Issue 3
Abstract
The present work studied the effect of filling epoxy matrix by different types and concentrations of nanoparticles on the friction and wear behaviors. Various concentrations (0.2 %, 0.4 %, 0.6 %, 0.8 % and 1 wt.%) of multi walled carbon nano tubes (MWCNTs), aluminum oxide (Al2O3), and silica (SiO2) nanoparticles were used to reinforce epoxy matrix. These epoxy nanocomposites are widely used as indoor flooring tiles in schools, boutiques, hospitals, offices, conference rooms, homes, trade fair stands and homes for the aged. Experiments involved sliding of the epoxy nanocomposite specimens against rotating steel disc at dry sliding condition. Experiments were carried out using a test rig of pin-on-disc, designed and manufactured for the test. The friction force was measured using load cell which connected with a digital screen to detect the friction force. All experiments were done at room temperature and carried out at constant normal load (7 N), constant speed (0.93 m/sec) and constant running time (300 seconds). The worn surfaces were investigated with back scattered scanning electron microscopy (SEM). Based on the observations in the present work, it was found that addition of the tested filling nanoparticles have greatly affected the friction and highly improves wear resistance.
Authors and Affiliations
M. A. Ramadan, R. Reda
Keywords
Related Articles
- EP ID EP229719
- DOI 10.24874/ti.2017.39.03.11
- Views 84
- Downloads 0
Mechanical and Tribological Characteristics of TIG Hardfaced Dispersive Layer by Reinforced with Particles Extruded Aluminium
The article presents the results of the implemented technology for generation of hardfaced dispersive layers obtained by additive material containing reinforcing phase of non-metal particles. The wear resistant coatings...
Development of a Constitutive Friction Law based on the Frictional Interaction of Rough Surfaces
Friction has a considerable impact in metal forming. This is in particular true for sheet-bulk metal-forming (SBMF) in which local highly varying contact loads occur. A constitutive friction law suited to the needs of SB...
The Factor of Structure and Mechanical Properties in the Production of Critical Fixing Hardware 38XA
Fixing hardware made of carbon, high-carbon, and alloyed wires is one of the widespread critical parts in mechanical engineering. The characteristics of fixtures and fasteners and their performance figures are assessed a...
Disk on Disk Test of Gear Pair Power Losses
This paper presents the research of friction in gear pairs by using tribometer that provides diskon-disk contact. When gear teeth mesh, there is a combination of sliding friction and rolling friction, and in that, the va...
Recycled Aluminium Cans/Eggshell Composites: Evaluation of Mechanical and Wear Resistance Properties
Aluminium based metal matrix composites have been produced from recycled aluminium cans and 150µm sized eggshell particles using a stir cast process. The mechanical properties of the control and aluminium can/eggshell co...