Comparative Analysis of the Effectiveness of Constructive and Design Methods for Ensuring the Stability of the Walls of Vertical Cylindrical Tanks
Journal Title: Металлические конструкции - Year 2017, Vol 23, Issue 3
Abstract
This article considers the normative documents of the USA, Europe and some CIS countries for comparison of calculation and design methods of vertical cylindrical tanks for oil and oil products. The need for such an analysis is caused by the widespread cases of local instability on the cylindrical walls of tanks. In addition to compare the calculation methods and design requirements, the article presents the results of analytical calculations for the stability of the reservoir wall in two design versions: with and without rings. According to the results of analytical calculations, stability stocks were determined, which give different norms. In addition, for each analyzed document unaccounted factors, which can lead to the loss of stability of the wall, are given. This gives us a direction for future research.
Authors and Affiliations
Volodymyr Mushchanov, Maxim Tcepliaev
Keywords
Related Articles
- EP ID EP448829
- DOI -
- Views 120
- Downloads 0
Numerical Researches of the Prop of a 65 kW Wind Power Plant
This article presents the results of numerical research of the steel lattice support of a wind power plant (WPP) from angle profile. The main purpose of the work was to determine the forces and displacements from the act...
Method of Calculation of Maximum Snow Loads on the Horizontal Area on the Territory of the Transcarpathian Region by Rendered Forms
The domestic scientists at the early stage of research revealed that maximum snow loads for the territory of the Transcarpathian region were determined only by the initial data of the snow cover of the III climatic zone,...
The Analysis of the Stress-Strain State of the Optimal Corner Dead-end Support of Overhead Power Transmission Line 110 kV
The analysis of the stress-strain state of dead-end OPTL support which is considered as spatial repeatedly statically indefinable through system with rigid joints is performed. The technique and results of calculation of...
Constructive Solutions of the Joint Connection of Space Structural for Industrial Buildings
The article presents analysis of existing technical solutions joints of space structures of coverings. The experience of domestic and foreign researchers in application of such structures to cover industrial buildings ha...
Study of General Stability of Large-Span Pipe-Concrete Arch Structures
The results of analysis of general stability of long-span shotcrete of the arched coverage are presented in the article. A calculation is produced in a calculable complex LIRA-SAPR 2013. The main purpose of work was dete...