Comparative Study on Dry Sliding Wear Behaviour of Metal Matrix Hybrid Composites at Room and High Temperature Conditions
Journal Title: International Journal of Engineering Research and Advanced Technology - Year 2015, Vol 1, Issue 1
Abstract
In this present study, hybrid composites was used to fabricate Boron Carbide (B4C) and Molybdenum disulfide (MoS2) particles reinforced aluminium Al2219,to achieve wettablity among Al and B4C the k2TiF6 halide salt was incorporated into Al 2219 alloy. The hybrid composites were successfully fabricated using stir casting technique and then casted samples were characterized by SEM examination. The microstructure examination demonstrate that uniform distribution of B4C and MoS2 particles in matrix Al2219.The monolithic Al2219 and prepared hybrid composites were subjected to Dry sliding wear test using pin-on disc tribometer as for ASTM G99-95 standard and comparative study between room temperature and high temperature(1800C) wear test under different sliding situation were done. The examination room result revels that, the specific wear rate at temperature was found lesser as compared to high temperature 1800C and the specific wear rate was found to increase with applied loads and sliding distances in both conditions. For both room temperature and high temperature the hybrid composites had lower specific wear rate when compared to Al2219.The specific wear rate increases with increases in load and sliding distance, the addition of reinforcing particles i.e B4C and MoS2 reduces specific wear rate of composites and the addition of secondary reinforcement MoS2 has significant effect on reducing wear rate of prepared hybrid composites for both room temperature and high temperature. The worn surface of pin samples tested under both conditions were analyzed using SEM.
Approximate Low power, high-performance Adder and Multiplier Design using Error Tolerance Application
The small error introduce some effect of application and also wastage area and power of the design but in this proposed design the error tolerance adder introduce in the design not affect design it reduces power, area, d...
A review on energy conservation in buildings by use of Air layers and Phase Change Material
Demand for energy has been increasing worldwide and the building sector represents a large percentage of global energy consumption which is directly connected with increasing global warming. In building Heating, Ventilat...
Effect of Weld Parameters on Mechanical Properties of Friction Stir Welded Aluminium Alloy6082-T6 and Soft Steel (Mild Steel)
Friction Stir Welding is a solid state joining process where a tool with pin, which is non-consumable, is used to join the two facing workpieces without melting them. This technique was invented in 1991 by The Welding In...
DEGRADATION OF ORGANIC POLLUTANTS BY INDIRECT ELECTROCHEMICAL OXIDATION PROCESS USING COMPOSITE ELECTRODE
The aim of this research work is to investigate the efficiency of electrochemical oxidation of industrial polluted water which contains Fast Blue B salt. A novel composite electrode was fabricated by pressing together Co...
Performance Analysis of Economiser, Air Pre-Heater and Electrostatic Precipitator of 210MW Power Plant Boiler
The main objective of the project is to study and understand the working and power production methods of MTPS-1. The boiler performance including its ability to meet full load, auxiliary power consumption, net plant heat...