Comparing Parametric Optimization of the Machining Parameters of Al2024-Sic for MRR using Taguchi and Applied Statistical Plots
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2017, Vol 7, Issue 5
Abstract
In today’s competitive world, the industries should have production systems which are capable of versatility, high production rate, precision and ability to produce highly finished goods. Due to this the value of input machining parameters responsible for the desired material removal rate becomes critical. In this thesis an experimental study is done in order to optimize and analyze the effects of process parameters in CNC end milling of Al 2024-SiC work material on material removal rate. Four machining parameters cutting speed, feed rate, depth of cut and number of flutes of the end mills are used. The experimentation plan is based upon the design matrix as per the Taguchi optimization technique’s orthogonal arrays. The predicted values of the output responses are calculated with the help of Minitab-14 software. The results are also verified with the help of confirmation experiments. The experiment is conducted by Al 2024-SiCp stir cast plates. The processing of the job is done by solid carbide two, three and four fluted ends-mill tools under finishing conditions. The experimental matrices are designed using an L-27 orthogonal array as suggested by Taguchi methodology and the analysis of variance (ANOVA) for analyzing the performance characteristics.
Authors and Affiliations
Atul Kumar, Neeraj Kumar, Sudhir Kumar, Rohit Garg
Keywords
Related Articles
- EP ID EP245167
- DOI -
- Views 106
- Downloads 0
Preparation of Al6061-Sic- Bagasse Ash MMCS By Using Stir Casting Method and Evaluation Microstructural, Mechanical Properties and Numerical Analysis
Metal Matrix Composites are promising materials for automotive, advanced structural, defense, marine, aviation, and applications, aerospace and other related sectors due to their tremendous combination of properties. The...
Comparative Analysis of Water and Nano Fluid in STHE Using Computational Fluid Dynamic
In this current work, study has been conducted on the shell and tube heat exchanger. CFD was used to carry out the analysis of this heat exchanger. Fluent software was used to project the pressure distribution. The effec...
Tip Leakage Effects on Flow Field of a Centrifugal Compressor
Tip leakage effects on the flow field of a low speed centrifugal compressor is observed computationally using structured multi block grid with fine grid in the tip leakage region. The computational study of centrifugal c...
Grain Refinement through Design Modification of ECAP Dies
The need for super-plasticity and high strength leads to the development of Severe Plastic Deformation (SPD) techniques. The strength of the material is directly dependent upon the grain size of the material. During the...
A STUDY ON OIL FIELD SANDSTONE THROUGH POROSITY AND PERMEABILITY PARAMETERS
Crude oil reservoirs have different formation types according to their environmental and geological conditions. Sandstone is one of the most common formations of crude oil reservoir, which has high oil bearing capacity t...