Comparison of extractability of Cd, Cu, Pb and Zn with sequential extraction in contaminated and non-contaminated soils
Journal Title: International Journal of Environmental Science and Technology - Year 2007, Vol 4, Issue 2
Abstract
Various extraction procedures were employed for measuring extractable concentrations of potential toxic elements in soil. The extractability of Cd, Cu, Pb and Zn in four contaminated and four non-contaminated soils of Japan, was compared by single extraction (CaCl2, DTPA, NH4Cl, 0.1 M HCl and 1 M HCl ) and sequential extraction procedures [(six operationally defined chemical phases, viz. water soluble (F1), exchangeable (F2), carbonate (F3), oxide (F4), organic (F5) and residual (F6) fractions)]. Extractability of metals from soils samples varied depending on metals and/or extractants used. Among the extractants, 1 M HCl extracted the largest proportion of Cd (79 to 96% of total), Cu (61 to 83%), Pb (51 to 99%) and Zn (23 to 52%) from soils followed by 0.1 M HCl, NH4Cl, DTPA and CaCl2. In all the extractants, the proportion of extractability of metals was higher in the contaminated soils than the non-contaminated soils. Regardless of soils and extractants, relative extractability was higher for Cd as compared to other three metals. The use of 1 M HCl may be recommended for first-level screening of soil contamination with heavy metals. The other four weak extractants are believed to provide a better assessment of bioavailable/mobile metals content in soils than 1 M HCl extractant. However, 0.1 M HCl mobilized all four metals irrespective of soil types, therefore, might be the best choice if only one extractant is to be used. The sequential extraction procedures showed 22 to 64% of total Cd was in the mobile fraction (sum of F1 to F3), while the corresponding values for Cu, Pb and Zn in this fractions were 2 to 23% suggesting higher mobility of Cd than other three metals. The single extraction procedures are simple and easy to perform and obtained results are comparable with sequential extraction procedure.
Authors and Affiliations
M. A. Kashem, B. R. Singh, T. Kondo, S. M. Imamul Huq, S. Kawai
Keywords
Related Articles
- EP ID EP118488
- DOI -
- Views 109
- Downloads 0
Assessment of the physicochemical parameters and heavy metals toxicity of leachates from municipal solid waste open dumpsite
Heavy metals and physicochemical characteristics of the different sites of the municipal solid waste dumpsite at Olusosun Landfill, Lagos, Nigeria, were investigated. The dormant site of the landfill has the potential of...
Specific methanogenic activity of halophilic and mixed cultures in saline wastewater
Wastewater containing high concentrations of salt, are difficult to treat using biological treatment processes, especially anaerobic processes. Limited information is available on methanogenic activity in saline environm...
Removal of Cr from synthetic wastewater by sorption into volcanic ash soil
The possibility of using volcanic ash soils (VAS) or Andisols as a low-cost and natural adsorbent is investigated in this study for the removal of Cr (VI) from synthetic wastewater. Andisols can be used as adsorbent beca...
Origin and chemical partitioning of heavy metals in riverbed sediments
In the present investigation, bulk and chemical partitioning of elements in the Shefa-Rud riverbed sediments are studies. Higher concentrations of elemental concentrations have been observed in estuarine zone when compar...
Nutrient acquisition and yield response of Barley exposed to salt stress under different levels of potassium nutrition
A greenhouse experiment was carried out in 2002 at Jordan University of Science and Technology, Agricultural Experiment Station to examine the effect of potassium fertilization on the response of barley (Hordeum vullgare...