COMPUTER CONTROLLED EXPERIMENTAL DEVICE FOR INVESTIGATIONS OF TRIBOLOGICAL INFLUENCES IN SHEET METAL FORMING
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2012, Vol 19, Issue 3
Abstract
Sheet metal forming, especially deep drawing process is influenced by many factors. Blank holding force and drawbead displacement are two of them that can be controlled during the forming process. For this purpose, an electro-hydraulic computerized sheet-metal strip sliding device has been constructed. The basic characteristic of this device is realization of variable contact pressure and drawbead height as functions of time or stripe displacement. There are both, pressure and drawbead, ten linear and nonlinear functions. Additional features consist of the ability to measure drawing force, contact pressure, drawbead displacement etc. The device overview and first results of steel sheet stripe sliding over rounded drawbead are presented in the paper.
Authors and Affiliations
Milan Đorđević, Srbislav Aleksandrović, Tomislav Vujinović, Milentije Stefanović, Vukić Lazić, Ružica Nikolić
Keywords
Related Articles
- EP ID EP119617
- DOI -
- Views 100
- Downloads 0
Investigation of possible causes for appearance of a crack in the welded joint of the ship winch frame
Ship winches are one of the most important parts of the ship equipment since they perform the most responsible tasks on various ships. In the majority of cases, the ship winches are welded structures. All the necessary c...
HIGH STRAIN RATE BEHAVIOUR OF AN AZ31 + 0.5 Ca MAGNESIUM ALLOY
The paper reports behaviour of magnesium alloy AZ31 (nominal composition 3 % Al - 1 % Zn – balance Mg) with an addition of 0.5 wt. % Ca at high strain rates. Samples were prepared by the squeeze cast technology. Dynamic...
STRUCTURAL DEGRADATION OF HETEROGENEOUS WELDED JOINTS
Developing the techniques of welding materials with higher dynamic strength onto the rolling surfaces of rails is one of the options for increasing their operational endurance. The subject of this paper is an analysis of...
NODULAR CAST IRON FATIGUE LIFETIME IN CYCLIC PLANE BENDING
The fatigue behavior of a component is strongly dependent also on the material and its surface condition. Therefore, the manner in which the surface is prepared during component manufacturing (surface roughness, re...
CORROSION OF COPPER PIPES JOINTS IN SIMULATED OPERATING CONDITIONS
Joining of copper pipes used for liquid media transport are made as demountable and fixation joints. This work deals with corrosion behavior of the joints made by soft soldering, hard soldering and fitting. Corrosion pro...