Computer Simulation of Continuous SPD Process Commercially Pure Titanium Using Virtual Full Factorial Experiment with the Influence of Friction Factors
Journal Title: Tribology in Industry - Year 2016, Vol 38, Issue 1
Abstract
With the use of computer modeling in the environment of the software DEFORM-3D virtual conducted a full factorial experiment process, equal channel angular pressing (ECAP) by method "Conform" of commercially pure titanium, which evaluated the effect of independent parameters (speed of rotation of the impeller, the friction factor on the side surfaces of the impeller and the factor of friction between the billet and the matrix). As a result of the experiment obtained the regression equation and identified the most important individual factors and their mutual combinations that affect the response parameter are the deformation forces.
Authors and Affiliations
V. I. Semenov , S. -J. Huang , L. Sh. Shuster , A. G. Raab
Keywords
Related Articles
- EP ID EP143724
- DOI -
- Views 115
- Downloads 0
Development of an Extrusion Process to Ameliorate the Tribological Properties of Heat Treated Al Mg Si (Cu) System Alloys Matrix Composites in Consolidated State
The developments of AA6061 aluminum matrix composites are of great interest in industrial applications for lighter materials with high specific strength, stiffness and wear resistance. In this article, the dry wear beha...
Biomimetics Design for Tribological Applications
Biomimetics, biomimicry and bionics are synonyms for the scientific discipline of creating new structures inspired by nature. Biomimetics systematically analyses the evolutionary processes of living organisms, their stru...
Effect of Microstructure on the Wear Behavior of Heat Treated SS-304 Stainless Steel
Sliding wear characteristics of some heat treated SS-304 stainless steel against EN-8 steel in dry condition have been studied in the present experimental work. Samples of SS-304 stainless steel have been heated in a muf...
Tribological Behavior of Aluminium Metal Matrix Composite with Addition of Bamboo Leaf Ash by GRA-Taguchi Method
The bamboo leaf ash (BLA) which was extruded from agro waste was used as a particulate reinforcement to produce economical AMMCs. The dry sliding wear behavior of Al-4.5 wt.% Cu alloy with the addition of 2, 4 and 6 wt.%...
Investigations into the Degradation of PTFE Surface Properties by Accelerated Aging Tests
This paper describes an accelerate aging procedure used for investigating the surface alteration of PTFE gaskets commercialized by two alternative producers. These gaskets are installed in modern process plants where tir...