Construction of a model for the distribution of radial load among the bearing's rolling bodies
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 6, Issue 7
Abstract
<p>We have proposed analytical and computer models related to the distribution of radial load among the rolling bodies in a single-row radial bearing.We have analyzed patternsin the geometry and deformation of parts, as well as gaps in the bearing without taking into consideration the different positions of centers of the inner and outer rings. The latter can significantly affect the distribution of radial load among rolling bodies and cause the slippage of rolling bodies on rings.</p><p>The present study aims to refine the estimated value of load distribution among the bearing's rolling bodies. The closer the result of calculation of load distribution, especially, on the central rolling body, to the actual value, the more accurately the resourceis determined. That largely defines the reliability of a machine, as well as the cost of repair and replacement of bearings. It is equally important when determining the fatigue strength and durability of the separator to know as accurately as possible the magnitudes and directions of action of radial forces on the rolling bodies at the edges of the bearing's loading zone. It is these forces that determine the loads acting on the separator.</p><p>We have constructed geometrical equations that link the radial encounters of rings, physical equations that relate the encounters of rings and rolling bodies to forces, a condition for equilibrium of the inner ring taking into consideration the different positions of centers of the outer and inner rings of the bearing. We have identified tangential forces along the rings'rolling tracks, which cause the slippage of rolling bodies in the bearing's loading zone;a formula for determining their values has been derived. The calculation of distribution of load among thebearing's rolling bodies based on the constructed analytical model demonstrates a 5 % decrease in radial forces that act on the central rolling body, and a 3 % increase in radial forces that act on rollers at the edges of thebearing's loading zone compared to known model. That improves the estimated resource of the bearing in terms of contact-fatigue damage to rings and rolling bodies by 18.6 %.</p>The new analytical model for the distribution of radial load could be applied in the theory of calculation of resource for bearings ofincreased lift capacityin terms of contact-fatigue damage to rings and rolling bodies considering the structure of the separator
Authors and Affiliations
Anatoly Gaydamaka, Viktor Klitnoy, Yuriy Muzikin, Vladimir Tat'kov, Iryna Hrechka
Keywords
Related Articles
- EP ID EP528292
- DOI 10.15587/1729-4061.2018.149964
- Views 39
- Downloads 0
Development of trenchless technology of reconstruction of «pulling pig P» pipeline communications
<p>The technology of trenchless reconstruction of pipeline communications has been developed by pulling a new polyethylene pipeline into a worn-out steel traction by the pig. The pig moves under the pressure of air suppl...
Effect of quench and temper on hardness and wear of HRP steel (armor steel candidate)
<p>The need for quenched and tempered steel increased, especially for the manufacture of the combat vehicle components. This steel is classified as high-strength and hardness and is bullet-resistant steel (armor steel)....
Investigating the influence of volumetric hydrophobization on the formation of phase composition of cement stone and its physical-mechanical properties
<p>We have examined the influence of the most widely used silicon-organic surface water repellent GKZH-11K on the physical-mechanical properties and the phase structure formation of cement is the fact that the introducti...
Computer simulation methods of redundant measurements with the nonlinear transformation function
<p>The studies of possibilities of methods of redundant measurements have found the high efficiency of the presented methods for increasing the accuracy of measurements. It is proved that the equation of redundant measur...
Development of a renewable hybrid power plant with extended utilization of pumped storage unit equipment
<p>The scheme of a renewable hybrid power plant with the extended use of the installed equipment of the pumped storage unit for the conversion of the photovoltaic and wind generators direct current to the alternating one...