Contour milling programming technology for virtual basing on a CNC machine
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2019, Vol 2, Issue 1
Abstract
A new technique and an application program for automating the programming of the milling operation during virtual basing of the workpiece on the CNC machine table is presented, when precise installation of the workpiece along the coordinate axes of the machine is difficult. The solution of such a scientific and technical problem allows you to perform contour milling of parts with their arbitrary location on the table of the CNC machine with guaranteed alignment of the allowance along the forming path. The method involves the sequential implementation of three stages with parallel use of the created application program. At the first stage, an electronic copy of the part drawing is prepared, which contains the selected part and workpiece contour highlighted in different colors. Thus, the scanning provides automatic creation of digital two-dimensional arrays of geometric images necessary to solve the problem. At the second stage, the coordinates of three points of the workpiece measured by the probe on the machine are entered into the created program. Based on the entered data, the created program solves the problem of alignment of the allowance using the Gauss-Seidel method using the Hausdorff dimension. This approach allows us to obtain a quantitative estimate of the similarity of polygonal objects, which is necessary to solve the problem of minimax location of the allowance. The task is to determine the correction of the control program for two linear coordinates and one angular around the center of mass of the workpiece. At the third stage, the correction values calculated in the program are entered into the CNC rack of the machine and the processing of the contour begins. The proposed technique and the created application program were tested when processing the part contour on a VF-3 HAAS milling machine. Practical testing has shown the effectiveness of the technique, which is to ensure milling without overloading the tool and reduce the processing time during virtual basing of the workpiece
Authors and Affiliations
Yuri Petrakov, Danylo Shuplietsov
Study of the influence of electric transmission parameters on the efficiency of freight rolling stock of direct current
<p>The negative impact of non-uniformity of current distribution in the power circuit of a freight direct current rolling stock on its operation efficiency was experimentally established. In contrast to existing approach...
The model to optimize deliveries of perishable food products in supply chains
<p>The probabilistic-statistical analytical model of optimizing the supply of perishable food products (PFPs) has been improved. The demand for PFPs is effectively satisfied by introducing into supply chain systems a pos...
Studying the possibility of using enzymes, lecithin, and albumen in the technology of gluten-free bread
<p>The comprehensive approach to the technology of bread for people suffering from celiac disease by applying amylolytic enzymes, lecithin, and dry egg albumen was scientifically substantiated.</p><p>The effect of amylol...
Estimation model of the diesel engine fuel system with an electromechanical device to intensify fuel supply
<p>The key directions of the development and improvement of the fuel supply system for internal combustion engines with ignition from compression of the fuel/air mixture were pointed out. The need for the comprehensive i...
Weakening of rock strength under the action of cyclic dynamic loads
We report results of experiment on the estimation of decreasing strength of natural stone exposed to repeated dynamic loading. The study was conducted in order to assess the feasibility of using natural stone for the acc...