Contributions in the Preparation and Processing of Composite Material Type Silumin 3 - Reinforced Matrix with S235JR Steel Mesh
Journal Title: Analele Universitatii "Eftimie Murgu" Resita. Fascicula de Inginerie - Year 2015, Vol 22, Issue 1
Abstract
In the paper are presented concrete data on developing technological batches of metal composite material (MCM) type Silumin 3-reinforced matrix with steel mesh S235JR, with the indicating of the parameter and of the distinct stages of work. The samples from prepared batches were cut along and across by water jet abrasive process and were subjected to a destructive testing program and microstructural examination, obtaining results in concordance with the desired quality. The abrasive material used for cut was GMA granite with the average mesh of 80, the particle size ranging between 150-300 μm, density 2300 kg/m3 and melting point 1240°C.
Authors and Affiliations
Remus Belu-Nica, Relu-Costel Ciubotariu
Keywords
Related Articles
- EP ID EP448787
- DOI -
- Views 79
- Downloads 0
Experimental Testing of Welding Saw Blade of Rib-bon
This paper presents the results of experimental electric welding with pressure butt of ribbon saw blades. The analyzes and tests carried out resulting conclusion is that this process is the best solution for the re-furbi...
Modal-Based Design Improvement of a Butterfly Valve Disc
The dynamic behavior control of a butterfly valve is important because, when one of the valve disc natural frequency is close to the frequency of vortex shedding, which appears when the valve is fully open or partially...
Theoretical and Experimental Research Performed on the Tesla Turbine - Part I
The paper presents the theoretical and experimental research performed on a Tesla turbine driven by compressed air and designed to equip a teaching laboratory [1], [2]. It introduces the operating principle of the Tesla...
Design and Control of the Electric Drive of the Anti-Hail Launching System
In the present, the Romanian anti-hail launchers are manually oper-ated. This means that the positioning of the launcher on the two direc-tions (azimuth and elevation) are adjusted based on the commands, by the human ope...
HydroHillChart – Francis module. Software used to Calculate the Hill Chart of the Francis Hydraulic Turbines
The paper presents the Hydro Hill Chart - Francis module application, used to calculate the hill chart of the Pelton, Francis and Kaplan hydraulic turbine models, by processing the data measured on the stand. After de-sc...