Definition of weight coefficient in two-stage automatic compensation based on LMS-algorithm and interference correlation characteristics

Abstract

Introduction. Two-stage digital automatic compensators of active noise interference based on LS and RLS-algorithms provide parallel processing of signals and capability to connect/disconnect additional compensation channel block. LMS-algorithm is widely used for synthesis of digital automatic compensators of active noise interference. Its advantage is low computational cost. When solving certain practical problems correlation characteristics of interference signals are either given or their estimates are obtained. Problem statement. The first stage of the two-stage digital automatic compensator provides compensation of interference in the main channel using compensation channel signals of one of the blocks and orthogonalization of signals in the other block. The second stage provides compensation of the residue interference using the obtained orthogonalized signals. Modules of the first and the second stage are single type weight totalizers. We need to determine weight coeeficient of the two-stage digital automatic compensator with orthogonalization of signals of part of compensation channels based on LMS-algorithms and interference correlation characteristics. Using LMS-algorithm there was obtained two-stage digital automatic compensator with orthogonalization of part of compensation channels that is quasi-optimal regarding the criterion of minimum mean square error and it’s feature is lower computational complexity compared to two-stage digital automatic compensators based on LS and RLS-algorithms. It can operate in modes when preocessing of the complete training package of the input data is carried out in the first and then in the second stage as well as in the mode of simultaneous operation of the stages. There have been acheived analytical expressions for defining weight coefficients of modules in the first and in the second stage of the automatic compensator determined on the basis of selective and precisely known correlation characteristics of input interference signals. LMS-method based two-stage digital automatic compensator efficiency analysis with simultaneously operating stages and its comparison with a known one-stage automatic compensator with the same number of compensation channels were conducted with the help of static modeling at various conditions of interference correlation matrix and various numbers of interference sources. Conclusions. The obtained two-stage digital automatic compensator with orthogonalization of part of compensation channels is quasi-optimal regarding the criterion of minimum mean square error and it has lower computational complexity compared to two-stage digital automatic compensators based on LS and RLS-algorithms. Weight coefficients of the automatic compensators determined on the basis of selective and precisely known correlation characteristics of input interference signals are optimal regarding the criterion of least squares and minimum mean square error respectively. The obtained two-stage digital automatic compensators provide capability to connect/disconnect additional compensation channel block and appropriate computational stage modules proportionately to the interference situation.

Authors and Affiliations

S. Zhuk, K. Semibalamut

Keywords

Related Articles

IC Discrete-Analog Correlators Accuraccy Improvements

Some variants to improve accuracy of the integrated circuits of asynchronous digital-analog correlators with a binary impulse response are discussed. Possibility of signal processing with an arbitrary impulse response in...

Increases of speed in systems of multistation access are with the code division of channels of СDMA on the base of height telecommunication platforms

The features of construction of systems of mobile radio communication on the basis of high-altitude platforms are given, the opportunities of increase of information speed are considered consecrate, it is shown perspecti...

A stabilizer with the small falling of tension on a regulative element

The principle of construction of low voltage drop stabilizers. The chart of stabilizer is offered with a regulative element on p-MOS transistor. Description and results of his researches is resulted.

Microstrip band-pass filter based on resonators with quarter-wave coupling

The synthesis procedure of the microstrip band-pass filter based on resonators with quarter-wave coupling is considered. The nonuniform microstrip line electromagnetic field complexity demands using of some mathematical...

Comparative characteristics of the bases of wavelets to represent the speech signals

Wavelets allow us to delineate both a low frequency signal characteristics, and high-frequency components. This property is a significant advantage in problems of speech signal processing in comparison with the windowed...

Download PDF file
  • EP ID EP308272
  • DOI 10.20535/RADAP.2016.65.26-39
  • Views 93
  • Downloads 0

How To Cite

S. Zhuk, K. Semibalamut (2016). Definition of weight coefficient in two-stage automatic compensation based on LMS-algorithm and interference correlation characteristics. Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування, 0(65), 26-39. https://europub.co.uk/articles/-A-308272