Design Of High Speed Data Transmission Systems Using Cooperative Diversity Wireless Networks.
Journal Title: IOSR Journal of Electronics and Communication Engineering(IOSR-JECE) - Year 2018, Vol 13, Issue 2
Abstract
Cooperative Diversity (CD) is a method in which different radio terminals deliver to each other for developing the total network channel capacity. We propose a high speed data transmission using efficient queuing system in wireless diversity networks. It provides the simultaneous data transmission of data for multiple users and increases the amount of data packets. To develop the robustness in ad hoc networks, the CDMAC algorithm is introduced in the physical layer. The MIMO technique sends and receives the same data signal simultaneously on a single radio channel. OFDM is a frequency-division multiplexing scheme used to reduce the interference. The ALOHA in cooperative diversity has the drawback of low throughput under heavy load conditions and collision. It sends the messages any time they want. Introduction of Slotted ALOHA Buffer CD it is expected to add some more advantages reduce the delay and transmits data packets simultaneously for achieving the high channel utilization with less interference. Queuing is used to increase the coverage optimization. The Wireless Channel's broadband characteristics improve the ALOHA network protocol performance.
Authors and Affiliations
Eqbhal Mohammad Abdul Mannan, Nagabhooshanam E. , Mohammed Moazzam Moinuddin, Laxminarayana K
Keywords
Related Articles
- EP ID EP439025
- DOI 10.9790/2834-1302026164.
- Views 91
- Downloads 0
Embedded Sensor Node for Wireless Network and Control System using CMOS RF Transmitter For Telecom Applications
Multi purpose wireless sensors node for wireless network and control system using CMOS QPSK RF transmitter is proposed. Embedded systems are often distributed and deployed in various environments. Wireless nodes attached...
Performance of (2x2) MIMO Communication Systems for Various PSK Modulation Schemes
As the demand of bandwidth is escalating along with intolerance for errors and latency, datacommunication engineers are looking for new ways to utilize the available bandwidth to the maximum and improve the quality of tr...
Timing Analysis of Generic Multipliers
Multiplications are very expensive process and slow the overall operation. The performance of many computational problems is often dominated by the speed at which a multiplication operation can be executed. A multiplier...
Design of Microstrip Patch Antenna for 5g Applications
This paper is embedded with microstrip patch antenna that is constructed for future 5G wireless communications. The antenna has a compressed structure of 11mm x 8 mm x 0.5mm, including the ground plane. This antenna is d...
Multi Objective Analysis of Standard Cells Using Sense Amplifier Based QDI Approach
The main aim of this paper is to design various Quasi- Delay-Insensitive (QDI) Standard Cell Templates with more energy efficient techniques for asynchronous Circuit design. Out of these, Pre-Charged Half-Buffer (PCHB),...