Determination of a traction electric motor diagnostic system taking into account the choice of the preferred elements with a varying failure rate
Journal Title: Інформаційно-керуючі системи на залізничному транспорті - Year 2017, Vol 22, Issue 4
Abstract
The purpose of study is the simulation the parameters of the locomotive traction motor diagnosis sys-tem to ensure a given level of reliability. The research was carried out on the basis of the multi-criteria optimization procedure, methods of the reliability theory and the recovery theory. The procedure of multicriteria optimization for the traction motor diagnostics system was presented that accounts for the following quality indicators: the number of diagnostic moments, and the mean time to failure. A method for constructing the moments of diagnosing components of a traction motor have been presented with the further determination of ra-tional volumes of diagnosis and determination of corresponding resulting moments of diagnosing the engine as a single system. The diagnosis moments are selected so that the failure probability of the components does not fall below the pre-set value. A new method for constructing a rational system for diagnosing a traction motor has been proposed by the definition of the Pareto criteria: the number of diagnostic tests, the mean time between failures. The Research was carried out with the State Program for the Strategic Development of Railways of Ukraine prepared by the State Research Center for Railway Transport of Ukraine in conjunction with the specialists of Ukrzaliznytsia, and Renovation Program of the Traction Rolling-Stock of Railways to the 2020 year. The necessary quality of the diagnostic system should be determined according to the diagnosed object, taking into account the requirements imposed on the latter. The system of diagnosing of a technical object depends on the production technology and the technology of renovation of the components used, which makes it possible to choose the performer of the repair work or the manufacturer of the components of the technical object.
Authors and Affiliations
M. I. Kapitsa, V. Laguta, T. Serdiuk
Keywords
Related Articles
- EP ID EP497495
- DOI 10.18664/ikszt.v0i4.111059
- Views 149
- Downloads 0
Microwave powermeter on the basis of the absorbing wall mismatch error
The article considers the relationships between mismatch error and the physical and mathematical model of the absorbing wall. Physical and mathematical model is represented by the heat equation with zero boundary conditi...
Features of occurrence and development contact destructions of rail heads
Principal reasons of destruction of rail heads are considered in the article. Clarified, in the result of exploitation on the surface of rolling of rails there invoke longitudinal cracks, that weaken connection of super...
A mathematical model of the rail, which has inertial characteristics, under the action of a speed mobile composition
An investigation into rail track operation under loads from the rolling stock by applying numerical methods makes it possible to obtain information on the impact on track and features of the deflected mode of the whole s...
Numerical studies of traffic safety conditions using mathematical models of railway track condition
To date, unlike the main railways, there is no scientific justification for the norms of permissible vertical and horizontal unevenness of industrial railroad roads where traffic safety is ensured. This is especially tru...
The peculiaritiies of assessing process design of current and projected technical condition of a vehicle during operation under ITS
The article presents the results of study assessment process modeling features current and projected technical condition of the car and vehicles in general during their operation. The following features of remote monitor...