Determination of thermal and physical characteristics of dead pine wood thermal insulation products
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2019, Vol 4, Issue 10
Abstract
The studies allowed manufacturing dead pine wood thermal insulation materials for the arrangement of premises. Raw materials for their production are wood fibers formed as flat boards. The mechanisms of the thermal insulation process during energy transfer through the material, which makes it possible to influence this process are determined. It is proved that the processes of thermal insulation consist in reducing the porosity of material. So, with a decrease in material density, thermal conductivity decreases, and vice versa. Modeling of the heat transfer process in the swelling of the fireproof coating is carried out, temperature dependences of thermophysical coefficients are determined. Based on the obtained dependences, thermal conductivity for dead pine wood products, reaching 0.132 W/(m·K) is estimated. In case of adhesive bonding of wood products, it decreases to 0.121 W/(m∙K) and when creating wood wool thermal insulation boards it decreases to 0.079 W/(m∙K), respectively. Features of inhibition of the process of heat transfer to the adhesive bonded wood wool material are associated with the formation of pores. This is because in small pores there is no air movement, accompanied by heat transfer. Thermal conductivity of homogeneous material depends on density. So, with a decrease in the material density to 183 kg/m<sup>3</sup>, thermal conductivity decreases 1.67 times, and vice versa, when using the board, thermal conductivity decreases only 1.1 times. This allows confirming the compliance of the discovered real mechanism of thermal insulation with the revealed conditions for the formation of properties of the inorganic and organic-mineral bonded wood wool material, as well as practical attractiveness of low-quality wood. The latter, in particular, relate to determining the amount of the binder component. Thus, there is reason to argue about the possibility of directed regulation of the processes of formation of wood thermal insulation materials using wood wool and inorganic and organic-mineral binder, which can form a fire-retardant film on the material surface
Authors and Affiliations
Yuriy Tsapko, Denys Zavialov, Olga Bondarenko, Nataliia Marchenco, Serhiy Mazurchuk, Oleksandra Horbachova
Development of a method for geometrical modeling of the airfoil profile of an axial turbomachine blade
<p>A method for geometric modeling of the contours of the suction and the pressure side profiles of axial turbomachine blades described by compound curves and formed by two sections has been proposed. Each section of the...
Acceleration analysis of the quadratic sieve method based on the online matrix solving
<p>The algorithm for the<strong> </strong>online matrix solving<strong> </strong>is proposed. The rate of acceleration of the basic quadratic sieve method based on the online matrix solving<strong> </strong>is investigat...
Chemical deposition of CDS films from ammoniac-thiourea solutions
<p>This paper investigates the process of chemical deposition of CdS films from ammonia-thiourea solutions. It was established that a change in the turbidity of solution occurs in the process of chemical deposition. The...
Influence of the properties of blast furnace slag on cast iron heating at pulverized coal injection
<p>In the course of the studies at two industrial blast furnaces, we established a change in the characteristics of slag mode and cast iron heating, resulting from the transition to the pulverized coal fuel injection wit...
Development of information technology of term extraction from documents in natural language
<p class="KeywordsCxSpFirst">It is shown that domain dictionaries are widely used at various stages of design and operation of software products. The process of dictionary development, especially term extraction, is very...