Development of the system for vibration diagnosis of bearing assemblies using an analog interface
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 5, Issue 9
Abstract
<p>We have proposed a system for early vibration diagnosis of gas-pumping units, specifically bearing assemblies with improved metrological characteristics. The technique makes it possible to solve the task of early diagnosis of roller bearings under adverse conditions of application. The study has shown that this is achieved through the use of tracking notch filters based on N-channel structures using the iterative-integrating converters. The simulation results of the 4-channel filter under actual input signals of bearing damage have demonstrated its effectiveness. Based on this, we have built the resulting model for the filter’s output signal. Here we show a functional circuit for the root-mean-square values detector with a model of the output signal from the tracking notch filter at actual input signals. To build a model of signal at the input to a root-mean-square values detector, we determined filter responses for each frequency, which is responsible for a certain damage. The time of analysis was selected so that it was equal to a period of the minimum beat frequency, that is, Ta=164 ms (for a bearing of type 222).</p><p>We investigated effectiveness of the device by simulating a damage to an actual gas turbine engine’s bearing. The procedure for analysis has been proposed and the generalized vibro-diagnostic criterion has been suggested, which takes into consideration the degree of engine’s load. This improves accuracy and reliability of preliminary analysis when diagnosing a roller bearing at the stage of the origin of the damage.</p><p>Characteristics are given for the electrometric measuring amplifier for work with piezoelectric sensors and the proposed charge measuring amplifier to work with piezoelectric sensors. Under condition for the imbalance of the input link, which is due to the non-identity of parasitic capacitances of the input cable. It is shown that the penetration of a network disturbance to the output of the charge measuring amplifier provides for the signal/noise ratio that is two orders of magnitude better than that for the electrometric measuring amplifier.</p>
Authors and Affiliations
Vasyl Dovhan, Vladimir Kvasnikov, Dmitro Ornatskiy
Keywords
Related Articles
- EP ID EP528214
- DOI 10.15587/1729-4061.2018.144533
- Views 78
- Downloads 0
Development of neuralnetwork and fuzzy models of multimass electromechanical systems
<p>The study objective was to construct models of multimass electromechanical systems using neural nets, fuzzy inference systems and hybrid networks by means of MATLAB tools. A model of a system in a form of a neural net...
Establishing the patterns in the formation of oxide films on the alloy Ti6Al4V in carbonic acid solutions
This paper reports results of studying the features of the formation of thin interference-colored oxide films on the alloy Ti6Al4V alloy in solutions of carboxylic acids. It has been established that a change in voltage...
Research of the impact of the method of heating of heat units on the qualitative characteristics of treated materials
<p>An analytical method for calculating the chemical potentials of the components of the gas-solid system based on thermodynamic calculations of carbon potentials of the С–О–Н–N gas mixture (combustion products of the me...
Examining a possibility of using purple amaranth in the technology for products made of yeast dough
<p>It was experimentally found that additives of purple amaranth (APA) have high enzyme activity, which is proved by high activity of the amylase complex: maltose number of 5 % water extract from dry foliage of purple am...
Development of the aeromagnetic space debris deorbiting system
<p>The study has considered the possibility of creating an aeromagnetic system for removing space debris from low Earth orbits. The peculiarity of the design of the aeromagnetic deorbiting system is the use of magnetic c...