Different ratios CrC particle-reinforced Cu matrix composite materials and investigation of wear performance
Journal Title: International Journal of engineering Research and Applications - Year 2018, Vol 8, Issue 7
Abstract
In this paper, Cu matrix composites (Cu-MCs) were fabricated using powder metallurgy (PM) technique and using different proportions of CrC particles in Cu matrix. CrC particles were added into pure Cu powder at different ratios as 5%, 10%, 15% and 20% by weight. The prepared composites were formed with 400 MPa pressure. The formed parts were sintered 60 minutes at 950°C. Sintered samples were evaluated by observating the density and scanning electron microscopy (SEM) images. Mechanical properties and microstructure of the produced composite materials (CMs) were investigated. Microscope examinations were carried out with SEM. Hardness, one of the mechanical properties, is determined by the Vickers method, which is a method of hardness measurement. According to SEM examination, the CrC phase in the Cu-MCs composed of coaxial grains were balanced. It has also been observed that the hardness increases with increasing CrC ratio. The wear behaviours of the produced CMs were analyzed with pin-on-disk wear test. According to this investigation, 50N and 75N loads were applied to the composite materials and wear depths, friction coefficient variation, wear diameter variation and weight loss were investigated at a slip speed of 0.4 m/s and a slip distance of 1200 m. According to these investigations, it was observed that as the ratio of CrC particle reinforcement increased, wear resistance amount increased regularly.
Authors and Affiliations
Mahir Uzun, Mehmet Mehdi Munis, Üsame Ali Usca
Keywords
Related Articles
- EP ID EP394944
- DOI 10.9790/9622-0807020107.
- Views 117
- Downloads 0
Network Reconfiguration of Distribution System for Maximum Loss Reduction Using Sine Cosine Algorithm
In this manuscript, the network reconfiguration problem is resolved of open loop distribution systems with an objective of maximization of loss reduction. Distribution system plays an important role in supplying the elec...
Design and Analysis of an Excavator Bucket
An excavator is a run of the mill water driven substantial obligation human-worked machine utilized as a part of general adaptable development operations, for example, burrowing, ground leveling, conveying loads, dumping...
Fingerprint Image Classification using Singular Points and Orientation Information
The fingerprint classification process is an essential task that reduces fingerprint matching time of an Automatic fingerprint identification system, where a large database is used. It is still a challenging task. The pr...
Efficient learning based Image Super Resolution via Sparse Representation
This paper addresses the problem of generating a superresolution (SR) image from a single low-resolution input image. Research on image statistics suggests that image patches can be well represented as a sparse linear co...
Internet Of Things: Architecture,Issues and Applications
Recent past year’s research on architecture standardization of IoT (Internet of thing) is going on, not yet concluded about standardization, It is still open and debatable how to make a standard platform. Thousands of re...