Dynamic Modelling and Control System of a Single Non-Slender Flexible Robot’s Link Rotating in a Horizontal Plane
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2016, Vol 2, Issue 1
Abstract
Most authors have ignored the effect of rotatory inertia and shear deformation. This practice is justified for slender flexible arms. According to the Timoshenko beam theory, the deflection due to shear force and rotatory inertia should be taken into account in modelling for high speed and high precision requirement when the ratio of the cross-sectional dimensions to length increases. Based on Hamilton’s principle and Timoshenko’s flexible beam theory, the dynamic model of a single non-slender flexible link is derived, and it is shown that the elastic motion is governed by a pair of coupled partial differential equations with coupled boundary conditions. Then the abstract form of the dynamic equations is studied, and the properties of the spectrum of the elastic operator appearing in the evolution equation are given. Furthermore, the eigenvalue problem of the elastic operator is solved in explicit form. The formulation and well-posedness of the state-space equation, as well as the transfer function of the dynamic control system of the non-slender flexible link, are studied by spectral analysis. Spectral analysis is used to study the well-posedness of the dynamic control system. The tracking control problem is studied and a feedback control scheme that controls the rigid-body motion and elastic behaviors simultaneously is derived based on a n-modal model. Closed-loop configuration of a control system, equivalent circuit of a dc-motor and the overall system block diagram are proposed. The stabilization of the closed-loop system is studied analytically. Finally, the tracking control problem is studied, a stabilizing feedback control law based on a n-modal model to suppress vibrations of the flexible link is derived, and the necessary and sufficient conditions that can guarantee the stability of the closed-loop system, are given. Simulation results are given as well.
Authors and Affiliations
Yuri Chovnyuk, Mykhailo Dikterjuk
Keywords
Related Articles
- EP ID EP199988
- DOI -
- Views 125
- Downloads 0
Hydrocutting of Frozen Food Products
The article aims to determine the peculiarities of macromolecule deformation behavior under conditions of a jet-shaping head that would allow to solve the issue related to the mechanism of increasing water-jet cutting po...
Development of Welding Consumables for Wet Underwater Welding of High-Alloy Corrosion-resistant Steel
This paper discusses a technology of mechanized wet underwater welding of high-alloy corrosion-resistance steel. The main aim of the investigation is development of self-shielded flux-cored wire for wet underwater weldin...
Experimental Improvement of the Technology of Cutting of High-pressure Hoses with Metal Braid on Hand Cutting Machine
In the article the review of the problem of improvement of technology of high pressure hoses cutting on the hand cutting machines is analyzed. Different methods of cutting of high pressure hoses into the billets are over...
Gears with Asymmetric Tooth Profiles and New Alternative Method of Their Manufacturing
The article presents a new gears cutting process – radial circular generating method and describes its multiple benefits for manufacturers of transmissions. The overall increase of efficiency is realized due to using a s...
Investigation of the Influence of Machining Factors on the Workpiece Deformation Mode in the Chip-forming Zone by the Finite Element Method
The results of studies of the impact strength, temperature factors and parameters of cutting tool geometry on the formation of the stress-strain and thermodynamic state of surfaces with different types of engineering mat...